Oil and Oil Filters
Chevy Blazer
Honda Accord EX

What is the best oil to use in the 1995 Chevy Blazer?

363738

Top Answer
User Avatar
Wiki User
2008-09-28 17:40:07
2008-09-28 17:40:07

Synthetic oil is always best but there are some engineering reports that suggest that you not change from traditional oil if the vehicle has more than 50,000 miles on it. If you decide to not use a synthetic oil, I'd stay with any of the Pennsylvania grade motor oils. Also, look for the engineering seals on the label. For use in an older engine, select an oil VISCOSITY that does not allow the oil pressure light to come on or the oil pressure gauge to drop too low. You can go with a slightly thinner (lower VIS) oil during the winter to help with starting. I'd start with a summer: 20 W 40, Winter, 10 W 30. If that is too thin for your engine, go up a little in the numbers. If oil pressure is low, try Kendall brand oil. It tends to increase your oil pressure.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

underneath the engine PS. that's where the oil drain plug is also

User Avatar

The oil pressure switch on a 1998 Chevy Blazer is on the side of the engine block. It is located above the oil filter.

User Avatar

The oil cap on a 1998 Chevy Blazer is located on the passenger side of the motor. It is just to the left of the manifold cover.

User Avatar

The oil sending unit on a 2001 Chevy Blazer is just above the oil filter. It is actually located on the diagonal to the oil filter to the upper left.

User Avatar

Mounted to the bottom of the engine in the oil pan.

User Avatar

thers a panel in the front underneth that says oil filter hatch 99'blazer lt 4wd

User Avatar

5 it could be between 4.5 and 5 qts. start with 4.5 and work you way up.

User Avatar

My Blazer 4.3L vortec holds about 4.5 - 5 quarts

User Avatar

The oil pressure switch on a 1997 Chevy Blazer is located on the bottom of the engine, near the oil filter. It monitors the output and pressure of the oil pump.

User Avatar

Yes, a NAPA 1040 oil filter is smaller but fits.

User Avatar

Under the front, behind the bumper.

User Avatar

It is inside of the oil pan and the oil pan is bolted to the bottom of the engine.

User Avatar

To drain the oil on a 1991 Chevy S10 Blazer, located the oil pan drain plug. Use a wrench to remove the plug and the oil will flow into the receptacle you have provided.

User Avatar

Mine is on the Drivers side of the Block, Behind the Intake Manifold.

User Avatar

Most carwashes have an Oil Change center. You should probably take it there/

User Avatar

It is inside of the engine oil pan. You will have to remove the oil pan to get to it.

User Avatar

Which sending unit? Oil or temperature? Or ?????

User Avatar

You have to take the engine out, unfortunately.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.