Best Answer

Buy some fuel system cleaner from your parts store.

User Avatar

Wiki User

โˆ™ 2004-11-14 16:33:18
This answer is:
User Avatar

Add your answer:

Earn +5 pts
Q: What is the best way to clean both the fuel lines and fuel injectors in a 1988 Chevy IROC Z28?
Write your answer...

Related Questions

How do you change fuel injectors on 1988 Chevy?

They come out the top of the throttle body. Clean area thoroughly before replacing the injectors to avoid any dirt getting in to the system.

Vacuum diagram for 1988 Chevy Nova?

how do you hook up vacuum lines in a 1988 Chevy nova

What size brake lines are on a 1988 Chevy Suburban?


Is there a fuel injector relay on a 1988 Chevy S10 2.5L?

No there is not, Probley need to replace ingnition module in the distributor if the injectors are not working.

Where are the fuel lines located?

1988 Chevy corsica fuel sending unit whai have a 1988 Chevy corsica i need to no on the fuel sending unit the bib line goes to what line and the two little lines go where please help

Where is the fuel pressure regulator located on a 1988 Chevy s10 v6 pick up?

It is under the air cap and behind the fuel injectors.

Does a 1988 ford F-250 have fuel injectors or carburetors?

Mine has fuel injectors

The injectors on a 1988 Chevy Scottsdale 4X4 do not work what could the problem be?

Could be poor or no fuel pressure due to a bad fuel pump. Also check the fuses.

1988 Chevy cavalier 2.8 fuel pump and injectors wont run?

it could be your fuel pump relay. it should be located under the hood in a box marked fuses or relays.

Will 1986 Chevy truck parts fit on a 1988?

NO. 1988 is when chevy changed everything.

What causes fuel injectors to not get power in a 1988 Ford Ranger?

What cause your 1988 Chevy truck not to blow heat at all replaced heater core and blen door actuator?

Have you checked your suction lines.

Will a steering column from a 1988 Chevy truck work in a 1988 Chevy suburban?

Yes it will, samething


Are the door interchangeable on an 1987 chevy truck and an chevy blazer 1988

What is the fuel pressure for a 1988 Chevy 5.3?

there were no 5.3 in production in 1988; but on a small block Chevy in 1988 you should have 22-25 psi

What is the wiring diagram for an 1988 Chevy Celebrity stereo?

what is the wiring diagram for an 1988 Chevy celebrity stero

How do you change the ignition switch in a 1988 Chevy Camaro?

How do i change the ignition switch in a 1988 Chevy camaro

Where is the 1988 Chevy engine control module?

In a 1988 Chevy pickup the ECM is located behind the glovebox.

What type of vehicle is a rearend with serial number 15555679 from?

It is out of a 1988 Chevy suburban It is out of a 1988 Chevy suburban

What is the Ignition timing for 1988 Chevy 454 engine?

what is the ignition timing for a 1988 Chevy 454 engine

Where are the fuel injectors located on 1988 gmc c1500?

the fuel injectors are located on the top of the throttle body, to get at them take off the air filter assembly, once you remove that you will see the two injectors on the top.

Can you put a 1988 Chevy truck bed on a 1987 Chevy truck?

Yes, But it won't look right. 1988 is when chevy redesigned the body / changed it.

Where are the fuel injectors on 1988 Mazda rx7?

there's four injectors you have two primary and two secondary , the primary injectors are on the top of engine very visible but the secondary you would have to remove upper intake plenum to get to them ...

How do you change your fuel pump on your 1988 Chevy cavalier 4-cylinder .?

Remove the wiring harness from your 1988 Chevy Cavalier fuel pump. Remove the fuel lines from the fuel pump. Remove the fuel pump retaining bolts. Reverse the process to install the new fuel pump.

Why does a 1988 s10 spit out air through the injectors sometimes causing it to miss?

Probably because the o-ring seals on the injectors are 23 years old...