answersLogoWhite

0


Best Answer

I leave the engine in place and just remove the transmission.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the best way to take out a transmission from a 1996 chrysler concord 3.5 should you drop the motor and trans out the bottom or leave the motor in place?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

2002 Chrysler concord when come to a stop feel little jerk and wont shift restart car works fine until it decides to do it again?

transmission problem? should be looked at right away before your walking


Where is transmission dran located?

it should be on the bottom of the transmission.


What are the torque specs for 97 Chrysler concord?

The 1997 Chrysler Concorde has more than 100 torque specifications. The head bolt torque specifications are 160 pounds and should be torqued in 40 pound intervals.


How do you change the transmission fluid on a 1991 Jeep Wrangler with a manual transmission?

Should be a drain plug at bottom of transmission Should be a fill plug at side of transmission - fill to this level


How do you change and check manuel transmission fluid in ford ranger 2002?

Should be a drain plug in the bottom of transmission Should be a fill-check plug in the side of transmission


When should you change transmission oil on a 2006 Chrysler 300?

at 61,000 miles as it states it on the owners manual.


How often should you change the transmission fluid on a 2006 chrysler town and country?

About every 70,000 miles.


Where is transmission pan on 1997 Mazda 626?

Should be on bottom of tranny.


Where is the battery at on a 1975-1976 Chrysler Concord motor home?

It is located in the floor. When you first step up in the camper, there is a compartment right when you get to the floor of the camper. It should flip up.


Should their be a small hole on the bottom back side of the transmission?

No, vents are on the top of the transmission. The outer dust boot covering the rear seal where the driveshaft goes into the transmission may have a small hole in the bottom of it, that would be normal.


Should a transaxle on a 2001 chrysler sebring have any play in it?

Certain parts of the transmission do have play built into them for oil clearance.


What happens if you put power steering fluid where the transmission fluid goes in a Chrysler 300?

Similar products should not be a problem