Ford Ranger
Timing Belts and Chains
Ford Fiesta

What is the cam belt position for a 1988 Ford Ranger pickup 2 point 3 liter engine A diagram would be nice if you have one?

111213

Top Answer
User Avatar
Wiki User
Answered
2009-11-16 20:57:31
2009-11-16 20:57:31

the key goes straight up on both the cam and the crank

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The 1999 Ford Ranger pickup truck speedometer sensor diagram can be obtained from most Ford dealerships. The speedometer sensor diagram can also be found at most auto-parts stores.

A Ford Ranger pickup truck wiring diagram can be obtained from most Ford dealerships. The wiring diagram can also be found at most auto-parts stores.

Haynes Manuals have all diagrams for the ranger including the one you seek

Just follow the fuel line from the tank to the engine. Along the way, you will find the filter.

From a crankshaft speed/position sensor.

I need a vacuum diagram for a 1987 suzu pickup 2.5 lt engine

Position 1. Bridge Pickup, Position 2. Bridge and Middle Pickup, Position 3. Middle Pickup, Position 4. Middle and Neck Pickup, Position 5. Neck Pickup

wiring diagram can be found in a haines or chilton 1984 ford pickup shop manuel.these books cost about 15 bucks to buy

where is the cranksensor on 1994 chevy pickup with a 6.5 engine

Need to know your engine size in order to anwer your thermostat problems.

I own a 97 pickup with a ka24e and the vacuum diagram is right on the hood. But a local Nissan dealership should be able to print a copy of one from their service manual for you.

Go to your local dodge dealer and ask if you can get a copy.

The 1997 Ford Ranger owners manual shows that ( 5 W - 30 ) is the preferred oil for the 3 available engine choices

how do you replace a turn signal flasher on a 1999 ford ranger pickup

In a 1999 Ford Ranger : The factory engines were either : The 2.5 litre four cylinder engine The 3.0 litre V6 engine ( and its flex fuel version ) The 4.0 litre V6 engine ( which is the Over Head Valve / pushrod design )

MAYBE... -------------------------------------------------------------------------------------------------------------- Yes. The only engine off the top of my head I can think of is the 5.9L I-6 Cummins. Go on YouTube.com and type in "Cummins Ranger." There is a guy with a Cummins Ford Ranger! :D Here's a link to YouTube. http://www.youtube.com/

The 1989 Ford Ranger pickup truck ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.

Yes. send email. i have a complete wiring diagram. rbrown@appeara.com

The 1997 Nissan pickup truck crankshaft position eight sensor can be found on the back of the engine. The positioning sensor will be halfway down the engine block.

10 degrees BTDC ( If the information on your VECI sticker in your engine compartment is different , use the sticker information - Vehicle Emission Control Information )


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.