answersLogoWhite

0


Best Answer

The cam diagram for the Isuzu Rodeo 1998 2.2 can be located at Rock Auto and Isuzu.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the cam diagram for Isuzu rodeo 1998 2.2?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Timing diagram Isuzu rodeo?

what is the cam diagram for Isuzu rodeo 1998 2.2


Torque spec cam pulleys 99 Isuzu rodeo 2.2l?

selam


What are the timing marks on a 1995 Isuzu Rodeo?

One (1) each on the cam and crank gears and on the outer timing case.


Where is a camshaft position sensor on a 2001 Isuzu rodeo?

It is located between the camshafts right behind the camshaft pulley's.


Could you please tell you On a 1998 Isuzu rodeo 3.2l v6 where does the cam shaft sensor connect to?

a two prong female wire connector coming from the left side wiring harness at the top of the motor. one of the two wires is orange.


Replace water pump 99 Isuzu rodeo?

the water pump is driven by the timing belt. highly recommended to replace the tensioner, tensioner and idler pullies, and cam seals.


Does the 98 Honda Passport v6 have an interference engine?

No this V6 is not an interference engine. However the cam belt should be replaced at 75,000 miles. Reason being is that the 1998 Honda Passport is nothing more than a rebadged Isuzu Rodeo, and was not built by Honda and does not have a Honda engine. It has an Izuzu engine.


What does it mean when your Isuzu Rodeo says Reduced power on instrument panel?

I had this same issue and it was a secondary fuel pump... There are two fuel pumps on the isuzu.. One at the gas tank and another that runs off the cam shaft.. The cam shaft pump is hard to find... you have to order it direct from the Isuzu warehouse.. And get ready for a heart attack when you do order it.. it is a 900 dollar unit.. Now the reduced power light could be other issues . There are several things that can make it go off.. In my case it was the cam shaft fuel pump..


Isuzu 320 V6 cam gear timing marks?

The cam gear timing marks for a Isuzu 320 V6 are located on the cam sprocket and the timing chain itself. The marks must be aligned with each other to ensure proper initial timing.


Does a corsa 1.7 di have a cam chain or belt?

if its the Isuzu engine its a belt


Where is the camshaft sensor located on a 2001 Isuzu Rodeo 4 cylinder?

On a 2002 Rodeo it is located just behind the 2 cam gears which are right up front on top behind the plastic cover. I had to loosen the valve cover(12 small bolts on top) and pull the spark plug boots off for clearance to remove/replace it. All in all it's relatively easy.


After how many miles do you check cam belt on Isuzu trooper?

You don't check it you replace it. 1990-97 Replace at 60,000 miles 1998 Replace at 75,000 miles 1999 up Replace at 100,000 miles