Best Answer

To hook up a gauge to measure fuel preasure and to run injector cleaner through it Fuel line pressure release valve. (schrader)

User Avatar

Wiki User

โˆ™ 2004-11-22 20:03:10
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: What is the cap covered nipple valve in the U of the fuel rail assembly of a 1998 Buick Century V6 engine used for?
Write your answer...
Still have questions?
magnify glass
Related questions

Where is the clutch bleed nipple on vectra c?

above the gearbox ,you can see it between battery and engine.

How do you fix the thread on engine block where oil filter goes on?

That threaded nipple is removable, replace it.

Where is the thermostat in a 91 ford explore?

top radiator hose, Engine side, metal nippile that attaches hose to motor,,,,,,,,,,,,,, Its under the nipple Top radiator hose,, engine side,,metal nipple that attaches hose to motor,, its under the nipple,,,,,,,,,,,,,,,,, be sure to put the new t-stat in with the larger brass side toward the motor.

What rhymes with cripple?


What is the nipple of the breast called?

A nipple is a nipple, simple as that. The sometimes darker // pinker skin around the nipple is called the aureole.

Where is Drain plug for 2002 PT Cruiser?

under the engine, passanger side. looks like a white nipple

What is close length of nipple?

Close nipple refers to the length of threading on a nipple. For example, a nipple with threading on both sides that does not meet in the middle would not be a close nipple. If you were to "CLOSE" the gap between the threads, making the threading span the complete length of the nipple, then it is a close nipple.

Is a worm cold blooded?

nipple nipple

How do you make the nipple big?

massage the nipple

What bra is just on the nipple?

nipple bras.

What is the nipple size?

The nipple is the raised part in the center of the colored part (areola) of your breast. The nipple size, is just the nipple measured with a ruler.

How do you change a water bypass hose in a 1998 Oldsmobile intrigue?

You have to remove the tensioner assembly, not just the tensioner pulley, but the whole assembly, in order to access the plastic bypass hose. Be very careful, as these pipes get old, the plastic becomes brittle, and possibly the flange end will break off and remain in the block when you remove the pipe, check the block opening carefully to remove all of the remaining flange. Also, be very careful when removing the lover pipe nipple into the engine block, if you try to pry the tensioner assembly off the block, you will probably snap off the machined nipple that locates into the block, Ask me how I know!!! Good Luck, it can be done but you need to move carefully and deliberately. (by the way, a rebuilt tensioner assembly costs about $80 US, the pipe is about $6. New tensioner assembly comes with the pipe)

People also asked