Ford Crown Victoria
Philosophy and Philosophers
The Difference Between

What is the capacity of a 1978 ford C6 transmission?


Top Answer
User Avatar
Wiki User
2011-10-20 21:48:29
2011-10-20 21:48:29

25-26 pints of Transmission Fluid Check level with engine running and oil warm.

the dry capacity is 7 quarts in the transmission itself. a truck tranny pan can and filter can be added to any car, and it adds an additional 2 quarts. the converter, varies by engine. convertor diameter vs capacity ( quarts ) 10" = 3 quarts 11" = 3.5 quarts 12" = 4 quarts 13" = 5 quarts

User Avatar

Related Questions

If your changing the transmission filter, it takes five quarts. If the transmission is completely empty, it takes about ten quarts to fill it up.

locate a transmission shop and make an appointment

transmission with 2 wheel drive is 24 pints transmission with 4 wheel drive is 27 pints

Usually a C6 transmission.

No the c6 is a 3speed automatic transmission that was used on earlier fords.

A C6 transmission including the torque converter will take 12.5 quarts.

Depends on the C6 transmission you have. They made several variants for different Ford Engine types for the FE and 385 Big Blocks. So For a 390 you will need a C6 that mates to an FE engine.

E4OD(transmission) with C6 in overdrive

its a standard ford C6 passenger car transmission. a truck C6 wont work as i believe the bellhousings are different. torino, fairlane, and Lincoln transmissions should be the same.

Our 1977 F-100 takes a 56" drive-shaft U-joint to U-joint

Yes, Type F is the correct fluid for a 1971 C6.

I'm not an expert on Ford transmissions, but, the C4 is usually considered a lighter duty transmission as it is used in cars for the most part, the C6 however, is used in Pick up trucks and high performance cars of the time period. I would say, depending on your needs, the C6 is the better transmission.

no the c4 is not compatible with the 302 you would need a c6

I believe that is a ( C6 ) 3 speed automatic transmission with the 351 in a 1989 Ford Bronco

Mainly because the C6 transmission only has 3 gears and no overdrive.

I want to say 5-6 Qt, but you should ask your mechanic.

Front ¼" Pipe Cooler feed/out Rear ¼" Pipe Return/in

The Ford C4 transmission can be identified by the following.The pan will be square and have 11 bolts.If there are 17 bolts, it's a C6.

I believe that is a version of the C6 - 3 speed automatic transmission

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.