The firing order is 1-3-4-2
There is someone with a Olds 455 in his Fiero, but he had to remove the trunk.
Drop the cradle & engine together
Pontiac Fiero was created in 1984.
The engine support cradle is usually what fails
The firing order on a 2.5 Pontiac motor is 1-3-4-2, 1 being in front. The chilton book shows the firing order and the wire placement on the dist cap. #1 is at 10 oclock.
1984-1988 pontiac fiero with the 2.5L engine or any pontiac with the 2.5L engine
Firing order on a factory 2.8 V6 is simply 1-2-3-4-5-6.
no were there junk any ways
it look lik you dont know realy what im asking!
How do you replace the alternator on a 1988 Pontiac Fiero
V6 firing order 123456 Yes in order. 4cyl 1324
Pontiac Fiero 2.8 liter V6 firing order: 1-2-3-4-5-6 distributor rotor turns clockwise back of car 1 3 5 distributor 2 4 6 front of car
what is the smog and vaccum diagram for the 87 Pontiac fiero 2.5L 4 cylinder what is the smog and vaccum diagram for the 87 Pontiac fiero 2.5L 4 cylinder
MAP Sensor LocationOn a 1987 Pontiac Fiero GT 2.8L V6. It is bolted to the end of the intake plenum on the passenger side of the engine compartment.
1-2-3-4-5-6 Distributor rotates clockwise.
Yes, sort of, The clutch is different.
It is at the bottom of the front engine bay wall off set to the passenger side.
Just one in the engine compartment under the thermostat cap.
On the exhaust pipe, from where it leaves the engine, but before the catalytic converter.
There is no Carburetor, this is a fuel injected engine
YES! You can put ANY small block Chevy into a Fiero. Visit here, http://www.v8archie.com/, there you can find the conversion kit (minus the engine) and answers to all of your questions.
what is the fuel pressure on a 1987 fiero gt
All 30 amp
It is a RWD