if its a full size fuel injected bronco 87 or later the pressure should be between 35 and 42 psi
96 EB Bronco 5.8L EFI what is the standard fuel pressure
On the fuel rail. The tank return line connects to it.
The fuel presure for the 2.9 liter V6 in a Ford RANGER is ( 30 to 40 PSI ) I assume your Ford Bronco II , 2.9 would be the same * with fuel injection
Motorcraft ( CM 4764 ) according to motorcraft . com ( no spaces ) new fuel pressure regulator for a 1988 Ford Bronco 351 cubic inch
Remove the fuel pump and relieve the fuel system pressure. Disconnect the fuel line then fix the fuel pressure gauge. Reconnect the fuse to the fuel pump and start the engine to check leakage. Tidy the surrounding of the fuel pressure regulator.
the pressure should be between 35 and 42 psi in the fuel rail. It has a valve like the one for air in the tires to measure the fuel pressure.... MOA.
I believe that is 30 to 40 PSI
Most vehicles only have one fuel pump, manual or electric. Correct answer is 2, a high pressure pump in the tank and another inside the frame rails under driver's feet.
The Ford Bronco has two fuel pumps- one low pressure feed pump inside the tank that necesitates removing the fuel tank to replace, and one high pressure pump midway along the driver side of the vehicle on the frame rail. Trace the fuel lines forward from the tank to find it easily.
yes low pressure in tank and high pressure on driver side before tansfercase but after fuel filter. if you follow the fuel line from the fuel filter backside you'll run right in to it
I have a 1988 Full Size bronco. The fuel filter for it is on the drivers sde frame rail just about directly below the gas pedal. Careful when you take it off cuz it's under pressure and you'll get sprayed with fuel
On a 1992 Ford Bronco : The electric fuel pump is INSIDE the fuel tank
Correct me if I am wrong but a fuel pump does not hold fuel pressure it maintains the fuel pressure needed for the vehicle to run. What holds the fuel pressure is the fuel injectors and believe it or not the fuel pressure not only regulates the fuel pressure but also holds it. If the regulator is bad your vehicle will not hold the pressure needed to run the fuel pulse dampener also plays a small roll in this question too
I'm not a mechanic / technician but I believe that is ( 30 to 40 PSI fuel pressure on the Ford 2.9L V6 engine ) with fuel injection
At idle 13-20 psi Key on engine off 23-31 psi
Fuel filter, fuel pump, or pressure bypass/relief valve is not providing the correct, enough fuel pressure at the injectors.
9 to 13 LBS (PSI) Correct answer is that if it is a 1996 to 2000 the correct fuel pressure is 60 to 66 with key on and not running 55 to 58 with it running at idle.
maybe the fuel pump is not supplying the fuel as it should check the fuel filter and the pump pressure or the air filter is clogged
Does it turn over? Does it have fuel, spark, compression? Is ignition timing correct?
Depends on the year, make and engine. Need more info.
install a fuel pressure regulator and set it to 36 psi idle in a stock motor
Replace fuel pressure regulator.
Have the correct tire pressure on a vehicle is important in help fuel economy, traction, and stopping distance. The correct tire pressure for a 1993 Honda Civic is 32 psi.
how do I replace a fuel pump on a 1993 Ford Bronco 302 5.0 L
what is the right pressure for a 1998 toyota tacoma pre runner