answersLogoWhite

0


Best Answer

18lbs.@2000RPM

User Avatar

Wiki User

โˆ™ 2005-02-03 02:28:06
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: What is the correct oil pressure for a 1997 s10 6cyc?
Write your answer...
Submit
Related questions

Why would the oil light on a 1997 Camry 4 cylinder stay on after oil and filter was changed and levels are all correct?

Oil PRESSURE is an indication of the condition of the engine's bearings. If the oil pressure is low, the engine is about ready to quit.


What is the correct oil pressure for a 1997 Tahoe?

60-80 psi cold, 30-45 psi hot.


Where is the oil pressure switch located in 1997 blazer?

The oil pressure switch on a 1997 Chevy Blazer is located on the bottom of the engine, near the oil filter. It monitors the output and pressure of the oil pump.


What does an oil pressure switch do in a 1997 Cadillac Catera?

oil pressure switch sends message to oil pressure gauge in dashboard,telling what the oil pressure in engine is


Oil pressure drops raises?

Correct. The oil pressure does fluctuate throughout the RPM range.


Where is oil pressure sensor located on 1997 Honda Civic EX 1.6L?

where the oil pressure sensor located on 1997 Honda Civic EX 1.6L


Where is the oil pressure sensor on a 1997 Jeep Grand Cherokee Laredo?

The oil pressure sensor on a 1997 V8 is on the top rear of the engine next to the distributor.


Where is the oil pressure sending unit on 1997 Buick le Sabre?

The oil pressure sending unit on a 1997 Buick LeSabre is located on the bottom side of the engine, near the oil filter. It monitors oil pressure to ensure that the pump is working properly.


What is the function of a vtec oil pressure switch?

The vtec oil pressure switch tells the computer when the engine has the correct amount of oil pressure for the vtec to engage.


What causes a 1997 dodge caravan to stall?

People have given all kinds of answers except the correct one. The most common reason for a stall is low oil pressure. The car has an oil pressure protection circuit that shuts down the motor when oil pressure gets below a certain level so that the bearings do not overheat. If the car stalls, then starts 10 to 15 minutes later, it is because the oil has cooled and thickened and has regained its pressure. Check the oil level. If you are 2 or more quarts low, the van will stall often as there are only 4.6 qts in the system and the protection circuit will kill the motor. Keep the oil at the correct level and this will not happen. The 1997 Caravan does NOT have an oil pressure protection circuit.


Where is the oil pressure switch located on a 1997 Chevy Tahoe?

The oil pressure switch on a 1997 Chevy Tahoe is located on the back of the engine. It is in the center-rear part of the engine.


Oil pressure is reading high on corvette but oil is at correct level. Does this indicate a bad sensor switch?

High oil pressure is good....


How do you get change engine oil light to go out after you change oil?

If the light was on before you changed the oil and you now have the correct amount of oil, and correct viscosity, then it can be that your oil pump is defective. not putting out enough pressure. if you have an oil gauge, if that shows oil pressure is OK, then your light can be shorted out.


1997 Pontiac trans am where is the oil pressure switch located 350 5.7 liter engine?

The 1997 Pontiac Trans Am 5.7 liter engine oil pressure switch can be found on top of the engine. The oil pressure switch will be near the intake manifold.


How do you remove an oil pump from a 96 Taurus?

there is no oil pressure in my 1997 ford taurus, but the oil is full?


Where is the oil pressure sending unit located on a 1997 Honda accord?

by the oil filter


What is the correct oil pressure for a 1987 corvette?

The 1987 Chevrolet Corvette oil pressure should be between 45 PSI and 40 PSI. The idling oil pressure will be slightly less.


Why is the oil light constantly on with at 1997 dodge stratus?

If the engine is not noisy then you have pressure. The cause is probably a failed oil pressure switch.


Where is the oil pressure switch on 1997 Pontiac grand prix gtp?

Next to the oil filter


High oil pressure valve train tapping?

are you using correct weight oil. is oil correct capacity.does oil filter need changing check these out before you look further


What could be wrong if oil pressure gauge reads nothing and the oil pressure light is on in a 1997 Cadillac Catera?

The oil pressure light is on due to the fact that there is no pressure from the oil, fill it up, and if that does not fix it, check for faulty wiring. P.S. There is no such thing as "Blinker Fluid."


Why does the oil light come on in your 1997 Plymouth breeze?

Bad sending unit, low oil, low oil pressure.


Why does a 1997 Chrysler Town and Country Oil light come on it has oil?

That light is for low oil pressure, not low level.


What might cause a 1995 Geo Metro oil light to stay on?

Low oil pressure. Now the question is does it really have low oil pressure or is this a false reading. Check the oil level and add as necessary. If it was low that is your problem. If not, You need to check the oil pressure sending unit for loose wires or a leak. If you find it is OK, then you will need to see if you indeed do have low oil pressure. You can have someone run an oil pressure test or you can simply replace the oil pressure sending unit as it may be defective. I would also replace the oil filter and make sure you are using a good quality correct filter. If replacing the sending unit, checking the oil level, and replacing the filter does not correct the problem, you will need to have an oil pressure test run. If you find you have low or no pressure, the oil pump has probably failed.Low oil pressure. Now the question is does it really have low oil pressure or is this a false reading. Check the oil level and add as necessary. If it was low that is your problem. If not, You need to check the oil pressure sending unit for loose wires or a leak. If you find it is OK, then you will need to see if you indeed do have low oil pressure. You can have someone run an oil pressure test or you can simply replace the oil pressure sending unit as it may be defective. I would also replace the oil filter and make sure you are using a good quality correct filter. If replacing the sending unit, checking the oil level, and replacing the filter does not correct the problem, you will need to have an oil pressure test run. If you find you have low or no pressure, the oil pump has probably failed.


Why would oil light come on on a 1997 Plymouth voyager if it has oil?

Bad sending unit, low oil, low oil pressure.

Study guides

๐Ÿ““
Create a Study Guide