answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What is the correct position of the thermostat on a 1995 Honda Passport 2.6?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace the thermostat on a 2001 Honda Passport?

WE DON'T KNOW!


Where is the location of the thermostat on a Honda Passport 3.2 engine?

The thermostat is located in the housing on the engine side of the upper radiator hose on a Honda Passport 3.2 engine. You will have to take the air filter tubing off to get to it.


94 Honda Passport with no heat What do you need to do to get it working again?

Replace Thermostat


Where is the thermostat on a 99 Honda Passport?

Not an easy job.You need to remove the intake manifold plenum to do it.


Where is the thermostat on a 1995 Honda Passport?

Thermostat is in the housing under the left coil in the housing connected to the radiator hose. Takes about 30 minutes, if that long, to change.


What is the correct fuel rail pressure on a 2000 Honda passport 3.2?

75psi to 85psi


When was Honda Passport created?

Honda Passport was created in 1994.


Where is the camshaft position sensor on a 1997 Honda Passport 2wd?

have you checked inside the distributor . good luck


Does a 1995 Honda Passport engine fit a 1999 Honda Passport?

No


How do you make a crankshaft position sensor work on a 1997 Honda passport with a 1995 block and 1997 heads?

To make a crankshaft position sensor work on a 1997 Honda passport with a 1995 block and 1997 heads will take a lot of work. You will have to redo everything under the hood.


Honda Passport Overheating?

Check to make sure you have the correct mixture of anti-freeze and water because anti-freeze also helps with overheating too. If you still have a problem check your thermostat. It could be stuck closed and may not be opening.


Where is the thermostat located on a 1994 Honda Passport?

top front of engine follow top radiator hose to where it clamps its in that housing should be two bolts