I dont know much but I know this: All these Acura's take the Dexron III and an additive. If you're draining the tranny and adding new fluid, you HAVE TO use the additive. Check with NAPA auto since they were the only ones knowledgable to tell me these things.
It is important to use the correct amount of fluid in a car. The 1988 Acura Legend takes about 3.2 quarts of transmission fluid.
Any type of SAE certified transmission fluid can be used in the 1997 Acura. The transmission should never be overfilled.
how do you add transmission fluid on 98 acura cl 3.0
Honda ATF-Z1 transmission fluid or a multi-import transmission fluid that meets the requirements for ATF-Z1.
Drain out the transmission fluid and replace with the correct fluid. Some types of transmission fluid are incompatible with other types of tranmssion fluid or with the transmission itself, and can destroy your transmission.
Honda ATF-Z1 fluid, you have to get it from your Honda/Acura dealer.
Honda- Acura ATF or Dextron III
Use only OEM Acura/Honda ATF DW-1 automatic transmission fluid. Do not use any other fluid that claims to be compatible.
The Acura recommended transmission oil is any SAE certified transmission oil. The transmission holds approximately 9 quarts of transmission fluid.
If it is an automatic transmission, you add transmission fluid with a long funnel through the dipstick opening.
8lts i think
A 1998ÊPlymouth Voyager requires an uncommon transmission fluid due to the turbocharge that this engine has. The correct transmission fluid is Mopar ATF+3.
There is a fill hole in the side of the transmission towards the middle facing inward. The fluid should be just high enough to not run out of the hole.
On my '94, I went through dipstick. Make sure you get the HONDA/ACURA fluid from the dealer.
where is the dipstick
2 quarts
To change transmission fluid on a Acura 3.2 TL you must first check the existing fluid level when the transmission is hot which takes 15 to 20 minutes of driving. Next you will need to dip the dipstick in the transmission fluid to check the level which should be between the third and second level of the dipstick. Use a funnel to add transmission fluid if necessary. Next start the engine and shift into each position and then apply the parking break and turn the engine off. Recheck the transmission fluid and add more if necessary.
To change the transmission oil on a 1988 Acura Integra drain the older fluid by loosening the drain bolt. Wait until it is done drain and cap the hole. Insert new transmission fluid in the transmission reservoir.
You require 3-4 when doing a fluid change, be sure to only use Honda/Acura brand
Mopar ATF+4
The correct automatic transmission fluid for that vehicle is written on the transmission dipstick.
In mine the transmission is a sealed system meaning you cant change/fill the fluid without disassembly.
Valvoline AFT
Dexron II ATF
Use only genuine Acura or Honda fluid and nothing else.