Ford Explorer
Ford Explorer Sport
Ford Explorer Sport Trac

What is the door reset code for a 2001 ford explorer sport?


Top Answer
User Avatar
Wiki User
2012-10-09 14:37:06
2012-10-09 14:37:06

Each vehicle has it's own factory keyless entry code

User Avatar

Related Questions

On my 2001 sport trac it is behjnd the backseat on the module

Each vehicle with keyless entry has it's own factory code

I need to reset my radio in a 2001 Mitsubishi Montero Sport. I do have the code. But the radio is in OFF mode. I need to get it to CODE mode. Thanks

The light will reset itself when the cause of the code has been repaired.

How to reset security code in 2001 Z3

the code p0304 is cylinder 4 misfire detected

You need to see what the code is. Most likely it is an O2 code or EVAP code both are very popular on that model. or... there is a crack (or cracks) on your gas filler neck (usually near the gas cap) and the computer is detecting that gas fumes are leaking. That's what the code was on my 2001 Explorer Sport.

change the sencer related to the code and reset the computer problem solved drive safe

The # 3 engine cylinder has a misfire On a 2001 Ford Explorer Sport Trac the engine cylinder locations are numbered firewall 3 - 6 2 - 5 1 - 4 front of vehicle

You use a scan tool after repairing the cause of the code that turned the light on.

You have to remove the passenger airbag and use a flash light and read the 5-digit code then try that code on the keyless pad.

i need to know how to set the radio when you battery goes dead and the radio says code its a 2001 mits monyero sports.

Me too want to know how!!! I changed battery on my 2001 montero and stunned to see need to enter code on radio in order to work. that is sucks!!!

Trouble code P1120 means: Throttle Position Sensor A Out Of Range Low (Ratch too low)

Your # 1 engine cylinder is MISFIRING The engine cylinder locations on your Ford Explorer Sport Trac are numbered : firewall 3 - 6 2 - 5 1 - 4 front of vehicle

If you have original code--dealer If not locksmith

Try unhooking both battery terminals +- for a few minutes, that should reset the system.

You can change the personal entry code Click on the link below Click on Owner Guides The 2003 Explorer Sport Trac Owner Guide ( which includes the keyless entry sytem instructions starting on page 65 ) can be viewed online

How do I get the code on my truck I locked my keys inside

if you still have the manual it's in there towards the middle.

You will need to remove the passenger side airbag. It is located on a plastic box and it will be labeled on the top. You will need a small mirror to read the code. It will be a 5 digit code right next to a bar code. Hope this helps.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.