What is the easiest way to replace heater core on 1988 Jeep Cherokee?
Easiest way: There isn't one. Remove whole dashboard.Upper passenger floorboard the core is located. Remove the in and out hoses in the engine compartment. Once dash is removed, which is a pain. The heater core will be exposed for removal.
Why do you not have hot heat inside vehicle at 30 degrees or less outside temperature but at 50 degrees it will be just fine on a 1988 Cherokee?
Replaced the heater core on a 1988 Ford Taurus and now you dont have bilnkers or hazards what might be the problem?
To replace the heater blower cable on a 1988 Ford F-150, first remove the driver's seat. Then, remove console side panels, glove box, and radio. Pull of AC control knob and detach console from the?æfront frame at its corners. Next, remove console side braces, right vent distribution, steering column cover and left vent distribution. Finally, remove the 10 clips holding the heater blower cable and replace.?æ?æ?æ
You have to pull the dash and all the lower fascia, then remove the box that houses the heater core. Take the clamps off the heater hoses from the engine compartment side of the firewall and disconnect the heater hoses. Disconnect the bracket that holds the heater core in place from the inside of the passenger compartment (if present.) Carefully remove the heater core and discard it. Install a new heater core reversing the above…
It is a major undertaking to replace the front heater core, or the AC evaperator. They are both housed inside a plastic chamber behind the dash. You have to remove the left side of the dash, and all associated wiring, lower the steering column, and open the AC system in order to get the Heater/AC chamber our to remove the top of the chamber and lift out the heater core. The Haynes manual gives a…
under the dash pass. side look at heater you will see a plug with several wires that look like thy go into the heater there is a one screw plastic cover over this area so your feet dont hit it remove then uplug the wires then take the 2 screws out of oval shaped sensor and pull it out of heater you will see some transister on the back side and a little coil…
i have a 1988 jeep Cherokee and all you have to do is take off the panel that goes around your radio and guages and eveything and once you have that off you should be able to get to the cigarette lighter its only like 2 or 3 screws then anothe 2 or 3 conections on the back...but im not sure about any of the other years
With engine warmed up and running, open the hood, locate both heater hoses, feel each heater hose with your hand. If both hoses are equally hot, I would suspect you have a temp blend door problem. Replace the temp blend door actuator. If one hose is hot and the other is only warm or cool, I would suspect you have a plugged heater core, Try flushing it.