Spark Plugs and Wires
Pontiac Firebird
Ford Ranger XL

What is the easiest way to replace the plug wires on a 1998 Pontiac Firebird with a 3.8 liter engine?

555657

Top Answer
User Avatar
Wiki User
2006-04-15 23:25:22
2006-04-15 23:25:22

I already answered this under spark plugs. If you cannot find it let me know david vol-dolfan@msn.com

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The 2000 Pontiac Firebird starter can be found on the right hand side of the engine. The starter will be near the back of the engine.

User Avatar

yes but you will have to replace the computer with one from a v-8 car

User Avatar

The EGR Valve on a 1999 Pontiac Firebird is located just to the left of the engine oil dipstick. There's nothing in the way so it's pretty easy to get to and replace. Hope this helps! -Erin

User Avatar

Can a v.8 5.7l 350 engine fit into a 1994 Pontiac firebird?

User Avatar

Take the top radiator hose loose from the top of the engine. The thermostat is under there. just pry it off with a screwdriver.

User Avatar

All 1993 Pontiac Trans Ams were made with the LT1 engine.

User Avatar

Bank 1 is the drivers side of your 5.7 liter V8 engine in a Pontiac Firebird

User Avatar

It is a Pontiac Firebird Third Generation produced from 1982 - 1992.

User Avatar

Something is wrong with the emissions system.

User Avatar

The firing order for the 1993 Pontiac Firebird is 1, 2, 3, 4, 5, 6. This is for the 5.7 Liter V8 engine.

User Avatar

I have a 1990 Pontiac firebird, and the gap on that, I believe is .035. If you still have the sticker under your hood with the engine size, it says it right on there.

User Avatar

Depends on what engine (V6? V8?), transmission, gearing, etc...

User Avatar

The 99 Pontiac Bonneville, Firebird and Grand Prix came with the 3.8 engine. The Sunfire came with the 2.2 or the 2.4. The Montana came with the 3.4. The Grand Am came with the 2.4 or the 3.4. The Firebird Trans Am and the Firebird Formula, the 5.7. Only the Grand Prix SE came with the 3.1.

User Avatar

The 1989 Pontiac Firebird oil sending unit is located on the bottom of the engine. You will need to remove the oil pan in order to access the oil sending unit.

User Avatar

Remove the wiring from the top of the EGR then unbolt it at the bottom of the EGR system. You may need to replace the gasket after replacing the EGR itself

User Avatar

check if you have an aftermarket turbo LOL

User Avatar

3.4L V6 with 160 hp or 5.7L 275 hp

User Avatar

It depends on the engine in it. Somewhere in the neighborhood of 110-115 MPH.

User Avatar

You can find the 1995 Pontiac Firebird 3.4 liter engine IAT sensor on the back of your engine. The IAT sensor will be a few inches above the transmission.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.