the sequence is (1-2-3-4-5-6) it sounds odd but its the V6 so it is kinda odd... lol
Have you changed your oil lately? You can try adding 10/40 wt. oil the next time you change oil.
The 40 amp motor probably produces double the horsepower of the 22 amp motor.
Yes this is what we call efficiency of the motor. We give 100 but the motor in turn gives 40, so its efficiency is 40%
you might try spraying WD-40 into the bearings of the fan and fan motor, and then spinning the motor by hand a few times. If this does work, you will have to add a regular lubricating oil to the places where you have sprayed the WD-40, as it will dry out fairly quickly. I would recommend using Gunk 'Super Oil'.
How much oil do I use per gallon of gas for a 40 HP Johnson motor
yes, 10-40 just a higher grade motor oil then 5-30 or 5-40 i run 15-40 in my Ford Explorer
.35 to .40
It depends upon the efficiency of the motor, but it will exceed (40 x 746 =) 29.84 kW.
5W-40 or 10W-40 will work
1 8 4 3 6 5 7 2 the same one they've been using for 40 years.
35 to 40 psi
The 40. 1997 Jeep Wrangler needs 6 quarts of oil for an oil change.
Two possibilities. Either the blower motor resistor pack is going bad or the blower motor speed switch itself is going bad. Try spraying the blower motor speed switch with a good electrical contact cleaner. Do not use WD-40. If that does not help suspect the blower motor resistor pack.
The engine computer is the voltage regulator.
It depends on the motor type, efficiency, and load on the motor. I found one example motor that draws ~100A at full load.
40 psi plus or minus 540 psi plus or minus 5
What is the continuous current of 10HP star delta motor
Could be a single phase induction motor of 20-40 watts.
pole mortor ms 225-40
on ebay £40