The 120 hp, Force / Mercury outboard, requires a 50:1 ratio, one pint of 2 cycle oil to six gallons of fuel.
The 120 hp, Force outboard requires a 50:1 ratio, one pint of 2 cycle oil, to six gallons of fuel.
625 amps - I just had to replace mine
50 to 1 i pint of oil for 6 gallons of gas
The 1998 model, 40 hp Mercury Force outboard requires a 50:1 ratio, one pint of 2 cycle oil to six gallons of fuel.
The gas/oil mix for a Force 50hp outboard is 1:50
I have a Force 70 HP from 1993 and it's 50:1
By 1996, Force outboards had been acquired by Mercury Marine. The 1996 models used a Chrysler / Force powerhead, carburetor, and mid section. The ignition system and the lower unit were of Mercury design, as were most of the trim units.
Depends on what you mean by service it? Change spark plugs, change lower unit oil, change impeller & thermostat, check 20 amp fuse, FULL decard, compression check, etc.....
A 40 hp Force/Mercury outboard, serial number OE050151, would be a 1994 year model.
What is the oil to gas ratio for a 15 hp force outboard moter
50:1 . 1 pint 2 cycle to 6 gallons gas
The listed dry weight for a 1993 model, 90 hp Force outboard is 249 lbs.
The 1984 model, 50 hp Force outboard requires a 50:1 ratio, one pint of 2 cycle oil, to six gallons of fuel.
The force of gravity on Mercury is 3.7m/s2
Is there a air filter for a force out board motor
50:1 for all Force Outboards
Depending on condition. does it have tilt and trim, are the throttle controls with etc .. between 600-1000 If in good condition. Hope this helps
Mercury has a force of gravity of 3.7m/s2.
50 hp Force 2-Stroke Outboard Motor. Force 50 hp Outboard is a long shaft. Force 50 hp only weighs 152lbs!! It is one of the lightest 50hp outboards ever made. This is advantageous as it will deliver 50 hp without weighing the transom down.
how much does a 1992 70hp force motor weight
the gravitational force of planet mercury is 38 times that of the earth..
The stator assembly on the 125 hp Force outboard provides both voltage for the ignition system, and charging system. The stator is located under the flywheel.
50-1 mix for 125 force 1989
The 1989 model, 125hp Force outboard, requires a 50:1 fuel, to 2 cycle oil mix.
The 1990 model Force outboard is of a 2 stroke design requiring a 50:1 fuel to oil ratio.
Asked By Ciara Parker
Give me food and I will live give me water and I will die what am I?
Asked By Wiki User
How 1600 x 1600 pixels in inches?
Asked By Wiki User
What is the fuel mixture for a 120hp mercury force outboard motor?
Asked By Wiki User
What classification instrument of tongatong?
Asked By Wiki User
What is Hugh hefner penis size?
Asked By Wiki User
What online sites don't ask for cvv?
Asked By Wiki User
What ACHIVR VISB on my bank statement?
Asked By Wiki User