In the ac box
Look in a removable housing at the engine end of the upper radiator hose
Air/fuel filter? Timing chain sloppy? Fuel pump?
According to my truck's('92) original window sticker that tank is 15.9 gallons.
The fuel filter on my 1991 d21 4x4 with 2.4l engine is located under the air cleaner and TBI. It was very easy to get to and replace. Good Luck !
It stands for nothing other than Nissan's model designation. In the U.S. the D21 is called the Hardbody.
ka24e engine is 33 psi vg30e engine is 34 psi
i drive a 1993 Nissan d21 pickup and the bed is 73in long by 55in wide
Fuel pump is going bad or the fuel filter is plugged near solid.
The fast idle-speed on a 1994 Nissan D21 pickup is adjusted by turning the screw on the side of the throttle body. It increases the speed of the engine when the vehicle is idle before completely warming up.
12 gallons and if mileage is over 100k your getting 18 miles per gallon. so 18 x 12 = 216 miles before refueling actually holding the repair manual in my hand right now and owning a subscription to all data, the capacity is 15 7/8, i know that's the fuel capacity on my 1990 D21
I went to autozone.com and looked both up and they are different.
they are the same truck,look em up at autozone.com,youll see what i am saying. D21 is the Official Nissan Designation of the Truck. Hardbody is the "Nickname"
86.5 from 720 to d21 hardbody.
There are 3 ways you can change the fuel pump. It is located inside the fuel tank. You can drop the tank or you can unbolt the truck bed and jack it up. Or you can cut a hole in the truck bed to access the pump. Either way the fuel pump is inside the fuel tank and you will have to decide how you want to approach it. Be very careful and safe while working on this.
use brake fluid dot 3
I have a 1991 Nissan ex-cab 4x4 D21 pickup. I would like to know what size the gas tank is. Answer: King Cab 4WD Tank (US gallons) 15.90
We found one out of a Pathfinder at a wrecking yard.
have you replaced and or tested both coils? are you getting no spark on the intake and the exaust sides?
gearbox will fit, but the bellhousing may need to be swapped if you have both it is only 4 bolts to swith a a bell housing from one gear box to another