What is the head bolt torque for a 1997 chevy lumina four cylinder?
The 1999 Pontiac cylinder head gasket bolt torque specification is 160 pounds. The intake manifold bolt torque specification is 90 pounds.
The 1995 Pontiac sun fire cylinder had bolt torque specification is 160 pounds. The head bolts should be torqued in 40 pound intervals.
The 3800 Pontiac engine had bolt torque specification is 160 pounds. The head bolts should be torqued in 40 pound intervals.
i don't now
The 1999 Pontiac Montana 3.4 liter engine cylinder head bolt torque specification is 150 pounds. The cylinder head bolts should be torqued in 50 pound intervals.
The head bolt torque specifications, for your 2002 Pontiac Grand Prix, is 160 pounds per square inch. The head bolts should be torqued in 40 pound intervals.
A 1993 Pontiac Sunbird head bolt torque sequence recommends starting at one and of the head and alternating to the other end of the head. You should end up in the middle.
The short bolt torque specs for the head gasket of a 2000 Pontiac Sunfire is 43 foot pounds. The torque specs for long bolts is 46 foot pounds.
HEAD BOLT TORQUE For your 1999 PONTIAC GRAND AM: HEAD BOLT TORQUE FOOT POUNDS (FINAL TORQUE) TORQUE SEQUENCE --------- | 6 2 3 7 | | 5 1 4 8 | --------- STEP 1: TORQUE IN SEQUENCE TO 33 FT/LBS STEP 2: TURN AN ADDITIONAL 90 DEGREES RECHECK FINAL TORQUE IN SEQUENCE *** CAUTION *** ENGINE USES TORQUE TO YIELD HEAD BOLTS (TTY) THAT PERMANENTLY STRETCH DURING THE INITIAL INSTALLATION. NEW HEAD BOLTS MUST BE USED WHEN CYLINDER HEAD IS REPLACED OR RE-INSTALLED TO OBTAIN PROPER TORQUE. ALWAYS COAT BOLT THREADS WITH THE PROPER SEALANT.
what is head bolt torque spec gm 3.1
1987 Chevy head bolt torque 2.5L?
how much torque on a head bolt
Answer HEAD BOLT TORQUE AND SEQUENCEyour answer is looking from front to back of engine you have ten head bolts to tighen start with 3,8,1,9,5 that's the back bolts now the front bolts there 4,7,2,10,6, now to torque, follow head bolt numbers torque each to 18 foot lbs now there is really no torque for these head bolts , you just start at a 90 degree point and go 60 degrees first time all the way around , then again 60 degrees .. now run the engine a few minutes , then go back and torque all head bolts to 30dgrees ( note very important) that clean all head bolt holes real good , and make shure treades are all clean and in good condition ......
What is head bolt torque for 2004 Suzuki forenza 2.0
head bolt torque specs 680 rincon
Head Bolt Torque Specs for1995 Suzuki Savage Ls650ps
cylender head bolt torque for 1993 Mitsubishi expo
What are the head bolt torque specs for a mazda mx3 1600
What is the cylinder head bolt torque for isuzu bighorn.
What head torque for e
What is the proper head bolt torque for a 89 toyota camry 2.2?
which one? The head bolts? Engine to transaxle? And, are you really asking what the tightening sequence and/or torque rating is?
whar are the torque specs for head bolt on a 1999 Mazda protege 1.6 engine
what are the cylinder head bolt torque setting for Honda Ballade 150i