0
15
Wiki User
∙ 12y ago
Wiki User
∙ 11y ago15
Add your answer:
Earn +20 pts
How does the hop count limit alleviate RIP problems?
A Google search for the phrasehop count limit rip problemsreturns a link which says the following."The hop count limit helps RIP instability by limiting the number of times a message can be sent through the routers, thereby limiting the back and forth updating that may occur if part of a network goes down."
Which network layer protocol enables routers to discover the best path between networks using hop count?
IP
In a RIP routing table what hop count indicates that the network is unreachable?
rip hop count is 15, if it reaches 16 it indicates network is unreachable
What are some of the advantages of IGRP over RIP?
Igrp RIP 100hops, extended to 255 hops 15 90 second updates 30 second updates Larger Networks Smaller Networks(due to 15 hop limit) Internetworking with Cisco and Microsoft Technologies Pg. 305
What metric does rip v1 use to update routing tables?
hop count metric
What is the maximum number of hops in Rip V2?
The maximum hop count for Rip version 2 is 15, with 16 being unreachable. This is the same as Rip version 1.
What routing protocol has a limitation of 15 hops?
RIP RIPnetworks are limited in size to a maximum of 15 hops between any two networks. A network hop with a hop count of 16 indicates an unreachable network. The other routing protocols do not use the hop count as the metric, EIGRP uses bandwidth and delay for the metric. OSPF and IS-IS use a relative link cost, BGP uses paths, rules, and policies for the metric.
What metric does RIP use?
There are approximately 80 acronyms for RIP: some of them are measurements, others are not. It is necessary to have more information in order to answer the question.
What are some identifying features of routing information protocol RIP?
It uses hop count in route selection. It is a distance-vector protocol.
What are features of RIP?
RIP Characteristics " RIP has the following key characteristics: RIP is a distance vector routing protocol. RIP uses hop count as its only metric for path selection. Advertised routes with hop counts greater than 15 are unreachable. Messages are broadcast every 30 seconds. The data portion of a RIP message is encapsulated into a UDP segment, with both source and destination port numbers set to 520. The IP header and data link headers add broadcast destination addresses before the message is sent out to all RIP configured interfaces.
What happens after 15 hops for rip routing method?
what happens in RIP ROUTING method after the 15 hop
What is the maximum allowable hop for RIP?
15
