It is located in the data link connector. There are three black wires. It is the bigger of the three black wires.
The Galant color code should be located on the firewall; sometimes it may be in the driver's side door along the front A pillar. Another possible location is the area near the radiator, where the hood closes. I have an '03 Galant and my color code is located on the firewall passengers side, the 2000 I think is on the driver's side firewall. You may have to clean dirt off of it to see it.
OK i have a '93 Galant of my girlfriends that I am trying to wire. This is what I found that helped me out the most. Go down to Chrysler/Mitsubishi Joint and it will show you the color in the dash...and the Modern harness color. http://www.installdr.com/Harnesses/DCP-Wiring.pdf That helped me alot. Only problem its says is not to use the illuminator or dimmer wires.
If your not sure, you can back flush the entire cooling system and then use any color you want. Just be sure to never mix the two kinds.
I think itsredishgreen
what two wires are the iat from the maf sensor on a Mitsubishi eclipse gs
The red wire is the hot wire. The black wire is the ground wire. The green wire is the speaker wire. The white wire is the auxiliary wire.
Looking for the ESC myself....the Knock Sensor wire is blue though.
Peak and Prestone both have a Universal fill (mixes with any color OEM antifreeze) premix antifreeze/coolant that works very well
Green with a white line
What color wires at the maf sensor belong to the iat sensor?
The chasis is the ground. There is no wire.
No. The color is determined by the star's temperature, not location.
not sure the exact location of the wire in the harness, but i can tell you that the speed sensor has 2 wire leads, that run directly to the PCM. they are in ports 20 and 21 on the PCM wire connector. Pin 20 is for speed sensor low signal and is Light green and black in color. Pin 21 is for speed sensor high signal and is purple and white in color
front of engine, behind the serpentine belt at the top of the timing chain cover. It is attached with one bolt/screw to the engine. Black in color and has a small harness that connects to the sensor.
code113 for iat sensor
2002 Mitsubishi Galant headlight bulb replacement: Purchase the correct replacement headlight bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the headlight bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
2007 Mitsubishi Galant tail light bulb replacement: Purchase the correct replacement tail light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the tail light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
Buy a Haynes or Chiltons Manual. They have wiring diagrams in the back with wire colors listed.
where is the 02 censor located
The Error 54.17 in the HP Color Laserjet 4700 signals a sensor malfunction. The malfunction has occurred in the sensor for the color Cyan.
Yes it does. Use the 'light sensor mode'. You can not use the default 'view' program to test the sensor.
2007 Mitsubishi Eclipse - ask for it at your paint dealer.
The downstream O2 sensor was broken and is missing the wiring harness, I have a universal O2 sensor, but need the color codes to wire it properly. It has a purple, pink, black and white.