16
The maximum length of cable that can be used for SCSI-3 is 12 meters. This is applicable to Ultra2 Wide, Ultra 160, and Ultra 320.
Depends on what the SCSI is. Ultra? Ultra Wide? Ultra Wide 2? many different types.
SCSI, Fast SCSI, Ultra SCSI, Ultra2 SCSI: 8 devices Wide SCSI, Fast Wide SCSI, Ultra Wide SCSI, Wide Ultra2 SCSI, Ultra3 SCSI, Ultra160 and 160+ and Ultra320 : 16 devices Of course, the number of devices supported depends not only on protocol limitations, but cable length, number of cables used, etc.
Ultra wide SCSI. wide SCSI buses support 16 devices, rather than the eight devices specified in regular SCSI.
68 pins.
It connects eternal device, connects power supply to analyze data.-Small computer system interface.-for peripheral devices connectivity (8 devices (0-7))-Internal and external buses like power supply and extensive peripherals.-Ultra SCSI - 32 devices (no wire is required, all with is uses is wireless).-Physical drive accession - (Single hard dish is physical drive).-Logical drive accession.-SCSI ID is available in the device.Configuration done in booting.-5MB/Sec.-SCSI: 2--Fast SCSI - 10MB/Sec.--Wide SCSI - 16bit 20MB/Sec.-SCSI: 3--Support 32 device - 40MB/Sec.Note: the above answer is in the form of points.
Wide SCSI bus can support up to 16 devices using channels 0-15.
It connects eternal device, connects power supply to analyze data.-Small computer system interface.-for peripheral devices connectivity (8 devices (0-7))-Internal and external buses like power supply and extensive peripherals.-Ultra SCSI - 32 devices (no wire is required, all with is uses is wireless).-Physical drive accession - (Single hard dish is physical drive).-Logical drive accession.-SCSI ID is available in the device.Configuration done in booting.-5MB/Sec.-SCSI: 2--Fast SCSI - 10MB/Sec.--Wide SCSI - 16bit 20MB/Sec.-SCSI: 3--Support 32 device - 40MB/Sec.Note: the above answer is in the form of points.
The wide SCSI-2 uses a wider data path & emdash;16 bit rather than the normal 8 bit & emdash; for the same 10 Mbps. Combining both fast and wide can, in theory, reach 20 Mbps.
16 devices can be connected
SCSI or Small Computer System Interface is a set of standards for connecting computers and peripheral devices for data transfer. SCSI is commonly used for hard disks and tape drives, but can connect a wide range of other devices like optical drives like CD/DVD drive if the specific device being connected supports the standard. There are different SCSI port types like parallel SCSI, serial SCSI, Fiber SCSI and iSCSI. More details can also be found on Wikipedia. http://en.wikipedia.org/wiki/SCSI - Neeraj Sharma
7 would be highest prority, then 6,5,4,3,2,1,0. For wide scsi, it is still 7, then 6,5,4,3,2,1,0,15,14,13,12,11,10,9,8. Scsi controller should be set to 7, and for hard drive, 0 CD-ROM=3 This is the standard, though as long as each device has a unique I.D. all should be well.