Top Answer
User Avatar
Wiki User
2010-09-11 14:40:53
2010-09-11 14:40:53

Click the link and choose the correct engine.


Related Questions

In the head at the end of the spark plug wires.

remove the spark plug wires one at a time and unscrew the plugs

Might need new spark plugs and maybe spark plug wires too.

This is a Honda only code which means you have a random cylinder misfire. If you have not replaced the Spark Plugs & Wires, do so now. Use OEM spark plugs.

OEM are the best spark plug wires for the Honda cbr. These spark plug wires can be found at the local Honda dealership.

It could be caused by not getting the spark plug boot on quite right after replacing the plug wires.

try replacing your distributor, distributor cap, rotor, and maybe the spark plug wires.

left side of engine directly under the distibutor (where the spark plug wires plug into)

there are four spark plug wires that run to the distributor..the fifth one is the coil wire

You may have the wires hooked up incorrectly. Click the link to see detailed photo of the correct connections.

change them one by one and matching up the length take em out and put new ones in...

all spark plug gaps are wrong ( dont always they set correct from factory) or you have got the plug lead positions wrong firing order 1-3-4-2

Not really the only parts that are interchangeable are the basics like oil filers, spark plugs,and wires. Different sized cars

Tune it up. Replace the spark plugs, plug wires, distributor cap, rotor, fuel filter, and air filter.

The 2002 Honda Civic EX engine uses coil-on-plug. There are no sparkplug wires.

different kinds , maybe a Honda plug , or , NGK .

The distributor wiring order for a 1996 Honda Civic is 1-3-4-2. The distributor will be have the wires in the clockwise position starting a 1.

Spark Plug Wires for my Honda Accord are as follows: 2 4 1 = 4 - 3 - 2 - 1 3 1 is the chamber to the far right. the diamond diagram represents the distributor cap if you were looking in from the left side of the car.

Yes it does have spark it does not have wires, they have boots from cylinder 1-5 and a diff one for 6th cylinder

The firing order for most four cylinder Honda vehicles are the same. These cars use 1-3-4-2. Incorrectly placed wires will not allow the car to turn on.

bad plugs or wires i just had this problem to or it could be a leak in the exhaust

usually the valve cover gasket and the oil seals on the top of the cover,replace gasket and the also the distributor seal

An O2 sensor unscrews like a spark plug and then there are 1-3 wires to rehook up.A special socket may be needed on some models.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.