answersLogoWhite

0


Best Answer

Yes that is correct. Front cylinders facing the front of the car are 2-4-6 rear cylinders are 1-3-5 Firing order is 1-2-3-4-5-6. Look at the link I posted below.

User Avatar

Wiki User

โˆ™ 2006-08-22 23:29:05
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: What is the order that the spark plugs go on the Front and Rear bank of a 1994 bereta Z26 clylinder and coil terminal Haynes book says it is front 2-4-6 back 1-3-5 however that is not correct?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where can you find a diagram that sHow is what wires go on which starter terminal on your 1985 Chevy van 10?

the Haynes repair manual should have a wiring diagram....possibly the internet.


You are replacing the coil packs plugs and wires. However the wires have been removed and you need to know how to safely install them in the correct order on a 2.8l. How can I get the information?

Go to an auto parts house and get a Haynes Manual. It is a good source for beginners.


What is the correct spark plug gap for a 1998 Toyota Corolla?

.043 inches, as per Haynes repair manual.


What is the birth name of Kiki Haynes?

Kiki Haynes's birth name is Kianya Haynes.


What is the correct placement of spark plug wires for a 1990 ford 5.0?

check haynes manual "firing sequence" or "firing order"


What is the brothers name of the Haynes sister?

Haynes


What is the birth name of Haynes Johnson?

Haynes Johnson's birth name is Haynes Bonner Johnson.


What is the birth name of Bradford Haynes?

Bradford Haynes's birth name is Bradford Narada Haynes.


What is the birth name of Jerry Haynes?

Jerry Haynes's birth name is Jerome Martin Haynes.


What is the birth name of Lloyd Haynes?

Lloyd Haynes's birth name is Samuel Lloyd Haynes.


What is the birth name of Wendy Haynes?

Wendy Haynes's birth name is Wendy Wylde Haynes.


How do you time 1998 Ford Contour?

According to my Haynes Manual the timing as not adjustable. It is controlled by the onboard computer. What can make a difference ,however is if the mechanical timing of the camshafts etc which is set when you change the timing belt or other repairs. Normally if the mechanical timing is correct the engine timing will be correct unless you have a sensor or computer problem. From the bigtomato

People also asked