answersLogoWhite
Chevy Silverado
Chevy Malibu
Crankshaft Sensors

What is the position location of a camshaft sensor on a 1998 Chevy Malibu?

252627

Top Answer
User Avatar
Wiki User
2006-10-28 21:07:16
2006-10-28 21:07:16

it is located behind the power steering pump. You need to remove the power steering pump to get to it which requires removing the engine mount next to it to get the bottom bolt out of the power steering pump. The sensor is directly behind the power steering pump. You can follow the cable that goes behind the pump. It is the only one there.

1

Related Questions

User Avatar

location of the camshaft sensor

User Avatar

were is the camshaft position sensor (cmp) location on a 1996 caprice classic

User Avatar

location of camshaft position sensor on 2001 exterra

User Avatar

show location of camshaft position sensor for 2002 Oldsmobile bravada.

User Avatar

The 2006 Dodge Durango camshaft position sensor is located on the back end of the head. The position sensor should be labeled as such.

User Avatar

A camshaft position sensor reads the location of the camshaft and sends that information the engine computer. This is needed for fuel and ignition timing.

User Avatar

The camshaft position sensor, on a Ford 6.0 liter power stroke engine, is located inside of the rear engine cover. The sensor is on the back of the camshaft.

User Avatar

The camshaft position sensor is most likely located on the cylinder head of the engine. The location could vary depending on the manufacturer.

User Avatar

Location of camshaft position sensor on 2001 toyota avalon 3000 motor

User Avatar

The camshaft position sensor is on the front of the engine block. It is on the right front about half way up.

User Avatar

A camshaft position sensor detects which cylinder is firing and establishes the coil firing sequence. In a Kia Sedona, it is located at the end of the intake camshaft.

User Avatar

The 2004 Chevy Malibu crankshaft position sensor location is dependent upon the type of engine. In most cases the crankshaft position sensor is on the back of the engine.

User Avatar

the camshaft position sensor is used to synchronize the fuel injection system with the opening of the intake valves. It synchs the cam shaft location with the crankshaft location It can be in a distributor or it can read a tone wheel on the cam shaft.

User Avatar

Where is the camshaft position sensor on a 2005 Expedition?

User Avatar

The 1995 for Crown Victoria camshaft position sensor can be found on the back of the cylinder head. The camshaft position sensor will be labeled as such.

User Avatar

where is the cam sensor located on a 2001 silverado ?

User Avatar

Camshaft position sensor circuit malfunction.Camshaft position sensor circuit malfunction.

User Avatar

CMP-camshaft position sensor CKP-crankshaft position sensor

User Avatar

The Pontiac 2.2 liter engine camshaft position sensor can be found on the back of each cylinder head. The camshaft position sensor should be labeled as such.

User Avatar

There isn't a camshaft position sensor. If you are asking because of an error code you received, it is caused by a signal that mimics the same signal as a camshaft position sensor.

User Avatar

The camshaft position sensor is located on the end of the camshaft housing, on a 2002 Daewoo. The sensor should be labeled as such.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.