Want this question answered?
Just unhook the positive battery cable for 5 mins.
the thick cable goes to the battery positive terminal . one thin wire goes to ignition switch
The proper way to use jumper cables to boost a low/dead battery: (1) one end of positive jumper cable to "dead" battery; (2) opposite end of positive jumper cable to "good" battery; (3) one end of negative jumper cable to "good" battery; (4) opposite end of negative jumper cable to GROUND on "dead" vehicle. Remove jumper cables in reverse order.
the red cable if there is no red cable usuallly the thicker cable is positive if that does not work look under your vehicle for the starter and fallow the thick wire back to your battery and that is you positive cable.
Is the positive battery cable for a 1989 cheyenne a fused cable? Can I buy this cable at a Auto Parts Store?
Connect the Positive + battery cable to the positive + battery post first. Then connect the Negative - cable to the negative - battery post.
Red cable to positive, black cable to negative.
depending on the year you can disconnect the positive battery cable for a few minutes and then reconnect it. it may reset the security system.
1. Remove negative battery cable 2. remove positive battery cable 3. remove battery 4. install new battery 5.attach positive cable 6.attach negative cable
buy the proper battery and the cable will fit, or replace the cable with on that will
To change the positive battery cable on a 1988 Jeep Cherokee trace the end of the cable to the starter. Unplug the battery then remove the cable from the starter. Measure the old positive cable with the new and be sure to replace the unit at the right size.
Most commonly there is a red cable and a black cable that conect to the battery. The red cable is the positive one. If the cables on your lawn tractor are color-coded, then the cable that connects to the battery post marked with a (+) is the positive.