you might try to move your steering wheel at the same time you are turning the key in the ingition. The lock mechanism might be in a bind.
No. The problem lies in the starter itself. Replace the starter and the vehicle will start....
A starter solenoid can be bypassed by connecting a jumper wire between the battery and ignition posts on the starter. This will cause it to spin immediately without using the ignition switch.
sounds like you have connected the wires wrong on starter. if that is not the problem then you have a short either in ignitin switch or in the solenoid
I know about the starter and ignition, but I click the ignition and then it clicks, then when I press and hold the starter it starts then immediatly stalls, I have tried it in neutral, in gear, with clutch, without clutch, with clutch and throttle.
The wires to the starter are probably connected wrong.
Did you just put a starter on it ??? Sounds like the starter wires are on the starter wrong are thay are shorted out. CHECK THE WIRES GOING TO THE STARTER CLOSELY.
check your positive on your battery. verify if no power is coming from the battery OR from the ignition. hard to answer without knowing if the problem is coming from battery or ignition. look for burnt wires going to the solenoid. hope you get a more precise answer. good luck. it could be worse!
yes without a problem
It sends a power to the starter relay/solenoid to engauge the starter. Know that the ignition switch is not what you put the key in and turn. That is the lock assembly. The ignition switch is located lower down on the steering column.
You can't.
I had the same problem the car started sometimes and sometimes did not. In my case i needed contacts, the contacts in the starter was bad. It cost me $500.00 so my advice is to buy a new starter the contacts were $12.99 a piece and later on i found out that you can buy a new starter for $500.00
For a remote auto starter to work, a person must first press his/her keyless control. This sends a radio signal to the module located within the car. The module activates the ignition. After the ignition is activated, the car starts up without the person having to do it manually.