This applies to most mirriors since year, make and model are not given. There should be a cover plate on the inside that pops off. Some do have a screw holding them. Remove this panel and there should be either 3 screws or 3 nuts holding the mirrior on. If it is a power mirror you will need to unplug the wire which you should be able to pull up enough widthout removing the door panel. Simply remove screws or nuts and the mirror will come off. Reverse the process with the new one.
See answer for replacing the driver's side. Same technique applies.
Replacing the side mirror will cost approximately $200. You can save is much as $125 by replacing the mirror yourself.
There should be a little black plastic covering over the mirror inside the car. Take it off. There are 3 nuts that you need to undo, after than its just putting the new one in its place and putting the bolts and plastic covering back.
The housing is broken not the actual mirror
It is possible if there is a mirror in the car. If the driver can see your eyes through the mirror, then you can also see the eyes of the driver.
1. Remove the triangular trim piece from the inside of the door. 2. Remove the three screws that hold the mirror on. 3. Disconnect the wire connector. Reverse procedure to install.
it is in driver mirror
how to install Ford Ranger Driver Side View Mirror
how to install driver mirror
On the driver side mirror adjust turn the adjust knob clockwise and that will allow you to adjust the driver side mirror. Turn the adjust knob back counterclockwise for the driver side mirroradjust
A good driver should constantly check their mirror - especially before carrying out any manoeuvre.
Remove the inside door panel from your 1991 Chevrolet 1500 pickup truck. Remove the wiring harness from the mirror. Remove the driver side mirror retaining bolts. Reverse the process to install the new driver side mirror.