The coils and the module are located on the firewall side of the engine. You have to take the coils and the module off at the same time. its a pain to get at, but it can be done. You'll need a 1/4" drive socket set and about 2 hours time. Some of the coils are located on the passenger front of the engine also. Just follow the spark plug wires to the coil packs. Once found, begin the repair.
Remove the retaining ring at the top of your 1994 Chevy Corsica ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
The 1992 Chevrolet Corsica ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
on the drivers side just under the exhaust manifold
Because it has HEI (High Energy Ignition).
If your 1988 Chevy Corsica key only turns in the ignition and does not start the automobile, it is probably unfixable. Remove the ignition switch retaining ring. Slide the out and remove the wiring harness. Reverse the process to install the new ignition switch.
The ignition modual is in the front of the engine compartment, below the front manafold between the motor and the radiator above the starter
Where can I download instructions for replacing the ignition switch tumbler on a 1984 chevy pickup?
Not an easy job requiring special pullers and tools. I suggest taking it to a garage.
The gas tank on a 1990 Chevy Corsica is 15.6 gallons. A 1990 Chevy Corsica takes unleaded gas not premium.
A 1989 Chevy Corsica 2.0 sedan weights about 2595 pounds. The 1989 Chevy Corsica 2.0 automatic sedan weight 2623 pounds.
where is the over drive solenoid located on a 1989 Chevy Corsica
where is the trunk release button for 1993 chevy corsica
it looks like a corsica
The evaporator for a Chevy Corsica can not be unclogged. When it gets blocked, the evaporator can only be replaced.
A Haynes or chiltons manual has the how to. Or do a search for a forum for Chevy corsica specific
Where is the Water Pump located and how do you replace it on a 1990 Chevy Corsica?
IF IT IS A 4 CYL YOU PROBABLY HAVE A BAD CRANK SENSOR OR IGNITION MODULE.
It is as simple as removong 2 bolts and replacing the mount. Goodluck, JOe
Because its a Chevy corsica not a ford corsica!!!!!
You need electronic equipment and know how to to diagnoise the ignition system of the new cars.
where would i locate the fuse for the fuel pump on a 1995 Chevy corsica
Ask the same question at batauto.com in the forum for transmissions. Koug
1991 Corsica its under the trottle body
removal of 95 chevy corsica