Modern electronically controlled engines use a sensor to keep track of the position of the pistons for spark timing. Since all the moving parts in the engine are mechaically linked, only one sesor anywhere in the system can provide the required information. Most systems put this sensor on the crankshaft. But a sensor on the camshaft would also work. The sensor itself is a simple magnet and pickup coil. The coil sends out a pulse every time the magnet passes it.
It differs with each engine some are in the distributor and some are in the engine block or cylinder head. They generally are small magnetic or Hall effect sensors that monitor camshaft revolution.
CAMSHAFT SENSOR TELLS THE COMPUTER THE POSITION OF THE CAMSHAFT IN RELATION TO THE CRANKSHFT so the computer knows which cylinder to fire in order
the camshaft sensor controls the timing of the injectors. it replaces the furl distributor on earlier cars
no
First, find the camshaft sensor. It will be right in the front of the engine near the valve cover. Disconnect the plug and remove the bolt. Pull the camshaft sensor out. Insert the new camshaft sensor and reattach the plug.
when you open your hood and you look on the valve cover you see on your left side of top of your cover a cable sticking out from a black piece that is the positioning sensor that cranksup the car.
It is a sensor that reads the rotational position of the camshaft. The engine computer uses that to control ignition and fuel timing.
This. is the sensor found on the cylinder head in the vicinity of the camshaft which inform the ECM of its position, so the. spark.could be sent to the cylinder for ignition.of the cylinder.
Most Camshaft Positioning Sensors are "Plug and play", if not I do not recommend playing with it if you are unsure have a mechanic do it.
there are many different things that it could be check the camshaft positioning sensor, the throttle positioning sensor, and the crankshaft positioning sensor.
where is the camshaft exhaust positioning sensor on the in-line 5 cylinder motor, 2006 hummer h3
To change the camshaft positioning sensor on a 98 GMC Jimmy you need to first locate it. The sensor is located within the distributor. Next, unbolt the old sensor and replace with a new sensor.
pro
The 2003 Mazda camshaft position in sensor can be found on the back of the left-hand cylinder head. The camshaft position sensor should be labeled as such.
Inside the distributor.
have never heard of a cam angle sensor. the cam does not change angle.it stays put in the bearings
still waiting on a answer , is it the same as a 2.3?
Cam position is taken from the distributor. There is no separate cam sensor.
the camshaft position sensor is on the left side of the engine , at back on the upper side . you have to demont the conector , than unscrew and replace it
There isn't one on the V8 or TDi