Chevy Silverado

What is the size of the automatic transmission in your 1995 Chevy 1 ton pickup with a 350 engine?

123

Top Answer
User Avatar
Wiki User
Answered
2009-11-02 20:04:16
2009-11-02 20:04:16

That would be a 4L80E automatic transmission.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


Will a Chevy blazer engine fit in a Chevy s10 pickup


It is on the side of the transmission were the shifter cable hooks to the trans.


Standard or automatic transmission, they both are mounted to the transmission.


An automatic transmission to bolt up to the original 1959 6 banger would have to come from a 1962 or older chevy/GMC 6 pickup or passenger car. 1963 and newer is completely different.


As with nearly all automatic transmission the fluid goes in through the dipstick tube.


If they are the same engine, it's highly likely the trans will be the same .



The 86 2.8L automatic transmission will not bolt up to a 71 Chevy engine.


It is in the gas tank, you will have to remove fuel tank to service the pump.


If it's a 1/2 ton it will have a 4L60E automatic transmission from the factory. 3/4 Tons had a 4L80E in them.


It's the part of the transmission that bolts to the engine block.


Depends on which engine it has and if it is a standard or an automatic.



It's between the engine and transmission. It slides onto the input shaft of the transmission and bolts to the flexplate on the engine.


I have a 98 S10 pickup with the 2.2L engine and standard transmission. I average 27 mpg.


yes 1973 to 1983 will work because this is before 1984 when wipers moved to the column in the full size trucks. it will bolt right in directly. good luck


Standard cab with a 4 cylinder engine and automatic transmission is rated at 5600#. Standard cab with a 4.3 V6 engine and automatic transmission is rated at 6000#. Extended cab with 4.3 V6 engine and automatic transmission is rated at 5500#.


A 1991 Chevy Van has a 4 speed automatic transmission. The engine on the 1991 Chevy Van is a 4.3 L V6 and a 6.2 L Diesel engine is also available as an option.


Change engine oil and substitute one of the quarts of oil with one quart of automatic transmission fluid. Run engine for 1000 miles. Change engine oil again with all oil.


Assuming this is a truck, if it has a standard transmission, TDC. If it has a automatic transmission, 4 degrees BTDC.


If it is a automatic its is the hydramatic 4l80e if it is a manual transmission it is a v 4500


Yes, as long as it has the Chevy bolt pattern.



If you have an automatic transmission, check with the engine warm and running, The dip stick is located on the passenger side rear of the engine.


The 1998 Chevy Silverado pickup truck shift solenoid can be found on the left-hand side of the engine. The shift solenoid will be near the center of the transmission.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.