What is the spark plug gap for a 2002 Ford Focus?

My 2002 Ford Focus ZX3 has a spark plug gap of .050" (1.3mm).

the spark plug gap is .054in. for 2003 ford focus.

On a 2002 Ford Focus , 2.0 : firewall 1---2---3---4 front of vehicle > driver

Spark plug gap is 0.030

The correct spark plug for 2001 1.6 Ford Focus is NGK TR5A-10 with a gap of 1.3mm

For the US model Ford Focus (2006), spark plugs are the only thing to replace. There are no spark plug wires. Ford recommends spark plug replacement at 100k miles.

Check the Vehicle Emissions Control Information ( VECI ) decal located in the front of the engine compartment ( it will show the type of spark plugs to use and the spark plug gap )

for the 2003 2.3 ford is located between the 2nd and 3rd spark plug wire

opposite end of the spark plug wire from the spark plugs

In a 2002 Ford Expedition : ( No , not really ) both the 4.6 and the 5.4 have the Coil On Plug ( C.O.P. ) ignition system , but there is a connection between the individual coil and the spark plug

For what engine ? 3.0

No , all it does it ground out to cause spark just like a spark plug

.044 inch for the 3.0 liter in a 2002 Ford Ranger

No distributor on this vehicle.

DO NOT GAP THEM... you will ruin the platinum finish and they will not fire correctly. Trust me, it cost me $150 to find that out. Install them right out of the box.

Pull the wire off the spark plug, pull the spark plug out, plug the spark plug back into the wire, then have someone turn the engine over. You should see a blue spark jumping around the very bottom of the spark plug.

Number 8 spark plug location on a 4.6 liter ford 2002. Is located on the Driver Side , Last one near the fire wall...

On a 2002 Ford F-150 : There should be an information decal in the front of your engine compartment that shows the type of Motorcraft spark plug to use and the spark plug gap ( the Vehicle Emissions Control Information decal , VECI )

Should be .050 inches.

Blown head gasket, burnt or bent valve, spark plug loose, busted piston, worn or broken rings,

Just buy the plugs and install them. If you stick a feeler gauge in them you will ruin the platinum coating and they will not fire correctly, IF at all.

The spark plugs on a Ford Explorer are replaced by first disconnecting the battery. Remove the spark plug using a spark plug socket. Replace with the factory recommended spark plug.

depends on the engine it could have 8 if it is a 4 cylinder some 4 cylinder do for a ford

The 2002 Ford Ranger in NORTH AMERICA has a 2.3 L DOHC four cylinder engine and the spark plugs are gapped at .044 inch

i dont know what size and make spark plug should be used 222