answersLogoWhite

0


Top Answer
User Avatar
Wiki User
Answered 2006-10-24 16:34:36

about 90 to 100 thousand miles would be accurate

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Still have questions?

Related Questions

How long would it take to replace a steering pump in a Dodge Durango?

In a 2005 Durango, aprox 1 1/2 hours.


How much to replace power steering unit 1998 durango?

um that is hard to say


How long does it take to replace a power steering pump in 2000 dodge durango?

It will take approximately 1.5 hours to replace the power steering pump in your 2000 Dodge Durango. The exact amount of time will depend upon the person that is doing the repair.


Can you replace the ignition lock cylinder on a 1994 Pontiac firebird without removing the steering wheel?

You can replace the ignition lock cylinder in your 1994 Pontiac Firebird without removing the steering will. Remove the retaining ring at the top of the ignition cylinder. The ignition cylinder will slide out.


Key in steering wheel won't turn?

You have to replace the ignition key cylinder.


What part is needed when the steering wheel locks?

Usually you have replace the ignition key cylinder.


How do you replace the ignition lock cylinder on a 2004 Honda civic?

The ignition lock switch is found under the steering column on a 2004 Honda Civic. Remove the steering column and ignition switch. Loosen the mounting screws that hold the cylinder in place. Pull and replace the lock cylinder.


How do you change the ignition cylinder on a 1987 Olds 98?

you will need to pull the steering wheel and column cover then it will be simpl to pull out cylinder and replace it.


How do you replace the ignition cylinder on a 1987 Chevrolet van If you need a special tool where can I get it or can I improvise Is replacing the cylinder and steering wheel going to be a problem?

You will need a steering wheel puller and a steering lock removal tool You rent them at yourlocal auto parts store


Is it possible to convert abs to standard hydraulic brakes on a 1990 Jeep Laredo?

Yes, replace the brake booster and master cylinder.Yes, replace the brake booster and master cylinder.


Do you need to remove steering wheel to replace key lock cylinder on a 1983 jeep cj7?

Yes.


How do you replace the ignition cylinder 1992 Bonneville?

I have not seen a way to do it without removing the steering wheel (and airbag).


How do you replace the power steering belt on a 97 Plymouth Breeze with a 2.0 4-cylinder engine?

how to change the reservoir of a power steering on breeze 1998


How do replace the power steering hose on a 2000 Durango?

The power steering hose is secured with a swivel nut on each end of the hose. Loosen the swivel nuts by turning them to the left. The power steering hose will come off. Reverse the process to install the new power steering hose.


How do i tighten my leaking power steering reservoir 97 Ford Ranger 4-cylinder?

Seals are probably shot. Replace the pump/reservoir assembly.


How do you replace the radio on a 1998 durango Specifically how do you remove the dash?

Gently pull from inside the steering wheel column. It only has clips. They pop right off.


How do you replace an ignition lock cylinder in a 1985 Buick Regal?

You have to remove the steering wheel, and it requires special tools.


How do you change the ignition lock cylinder on your 2001 Dodge Durango?

this is for a 2002 doge durango, it must be the sameLOCK CYLINDERREMOVALThe ignition key must be in the key cylinder for cylinder removal.# Disconnect negative cable from battery. # Remove upper and lower covers (shrouds) from steering column. # Place shifter in PARK position.# A retaining pin (Fig. 9) is located at side of key cylinder assembly. # Rotate key to RUN position. # Press in on retaining pin while pulling key cylinder from ignition switch.INSTALLATIONThe ignition key must be in the key cylinder for cylinder installation.# Install the key cylinder into the housing using care to align the end of the key cylinder with the ignition switch. # Push the key cylinder in until it clicks. # Replace the upper and lower shrouds. # Reconnect the battery.


How do you replace a durango water pump pulley?

replace the pump


How do you replace the ignition switch in a 1990 Chevrolet Corsica with tilt wheel?

The switch is on the steering column about 18 inches from the floor. Simply take 2 screws holding it on and replace it.The locck cylinder is under the steering wheel.


Do you have to remove the steering wheel to replace the ignition cylinder of a 94 Cadillac Sedan DeVille?

unfortunately yes you do. j to the izzo


How do you Replace Steering wheel fluid?

Remove the plug on the bottom of the power steering fluid pump. Drain the power steering fluid out. Replace the plug to the bottom of the power steering pump. Replace the power steering fluid.


How do you replace the leather steering wheel cover on a Volkswagen Jetta if standard wraps are too thick?

best to buy a Toyota


Do you have to remove the steering wheel to replace the ignition cylinder?

Not enough info to answer. Please re ask question and include the year, make, and model.


How do you replace steering rack audie a4?

How to replace power steering pump on Audi