Fuel injected vehicles have the pump located in the gas tank. You must remove the fuel tank to change the pump. Un hook all accessible fuel lines, fuel fill tubes and electric connectors. Support the tank from underneath (make sure it is well supported because they can be heavy and unwealdy when they have a lot of gas in them). Unstrap the tank and lower enough to finish unhooking all connections. Remove pump assembly from top of tank.
Mopar part # 5281090
Power and ground
If it is an A/T you add the same place you check it. If it is a Manual transmission, then you add lube under the vehicle on the upper side of the transmission.
the chiltons manual for my 1990 B150 dodge ram van states 80 inch pounds. For a Ram 2500 with 5.9L Cummins 12 valve engine. The torque should be 18ft-lbs or 24Nm.
Under the hood by the latch in that black box.
Dodge full size van b series B150,B250 all are rear wheel drive with 3 engines v6, 318,360
In the oil pan.
Back of the engine next to the distributor.
It may be an internal regulator in the alternator. The engine computer is also the voltage regulator.
my 94 dodge ram van b150 has a 22 gal tank, gets 16/17 gal a mile city/hwy and gets about 352 miles to the tank
Loosen the alternator bracket, move it out of the way. The thermostat is at the end of the upper radiator hose where it curves into the engine
V6 1-6-5-4-3-2 V8 1-8-4-3-6-5-7-2