It could be a suspension part such as a control arm. I just had replace the rear control arms on my 1993 Toyota Celica because the bearings in the control arms were worn out. It made a lot of rattling and thumping; when I replaced the arms the sound stopped.
you have a definete wheel bearing problem. have it replaced asap
most likely you have a loose bearing.
Could be a bad tire? Could be a bad wheel bearing?
Assuming it didn't do it before, sounds like something's loose or possibly they ruined a C/V joint on the axle. I'd have it checked right away.
mainly two types of Vibration measurement: shaft vibration Bearing Vibration
Bad bearing in compressor?
Answer 1It' possible that a badly worn seal which was already on the verge of failure could be "pushed over the line, and caused to leak by the severe shock and vibration involved in a tire separation failure, BUT a good bearing seal should not leak.
Center bearing should be replaceable after removing driveshaft
Bad tire? try moving it to another location on vehicle Bad wheel bearing?
its the center carrier bearing in the 2 peice driveshaft...have it replaced or go to a 1 peice driveshaft
I recently had to have a bearing replaced on a tire. My car was making a loud vibration and I thought I had ran over something causing a tire issue. I ignored it for a few weeks before I took it to a mechanic to diagnose. It was a bad bearing and he said it was close to "seizing" (which he said means that the tire would have fallen off the car).
It is most likely caused by a rotor that is warped. When you step on the brake pedal, the brake pads pulse against the uneven surface, causing a "thumping" you can feel. Other possibilities could include a bad wheel bearing or a tire that has tread that is separating.