Auto Parts and Repairs
Timing Belts and Chains
Ford Ranger XLT
What is the timing for a ford 302 1979 F100 I dont have a sticker left in the engine compartment?
According to the 1984 Chilton's Auto Repair Manual,the ignition
timing on all 1979 Ford 302s would be 6 degrees before top dead
center.The factory allows a tolerance of plus or minus 2
Asked in Ford F-150
What is the ignition timing for a 1979 Ford F150 4.9 6 cylinder engine with standard transmission?
Asked in Dodge Colt
Where are the timing marks on a 1979 dodge colt 97.5 cubic inch engine?
Asked in Chevy Camaro
How do you set the timing on a 1979 camaro that has no pointer?
Asked in Mercury
What could cause a engine fire on a mercury 115hp 1979 engine?
What is the timing setting for a 1979 Ford 400 with a V8 engine?
Asked in Chevy 350
Why is the timing mark on a 1979 Chevy 350 on the opposite side from your timing grid but the engine runs fine?
Asked in Ford E-150 Van
Where is Vin location on 1979 Winnebagos model brave?
Where would the engine size be found under the hood of a 1979 Chevy Malibu?
1979 Chevy Corvette 350 5.7l engine Why would coolant leak from the timing chain area?
Asked in Pontiac Grand Prix
What are the timing settings for a 1979 grand prix?
Asked in Dodge
What does the vent tube from the NP205 transfer case from a 1979 Dodge Ramcharger connect to in the engine compartment?
Asked in Dodge Power Wagon
What is the correct timing for a 1979 dodge 360 engine?
Asked in Chevy Silverado, Ford F-150, Algebra
How do you install a distributor in a 1979 Chevy Silverado?
The is to Bring the engine to TDC ( Top Dead Center ) you can do this by removing the drivers side valve cover and watching the intake valve.. crank over the engine until that rocker arm opens then closes... also there is a timing hash and timing mark on the timing cover, and harmonic balancer. once this is done set the rotor on the distribur so that once it is in the motor it points the Cylinder #1... then install dist cap, then adjust timing using a timing light.... Hope this helped...