The torque is 89 inch pounds or 7.41 foot pounds. You should never reuse a transmission gasket. If you are doing work on the transmission, replace the filter, it usually comes with a new gasket.
Could be either transmission pan Gasket, Axle Seals or torque convert seal, that's the seal that goes between torque convert and transmission.
There is no gasket between the engine and transmission. The torque converter inspection plate does have a dust seal on it.
usually no more than 35 ft lbs with new gasket
What is cylinder head torque specifications for 97 Chevy lumina 3.1 v6
Bad pump Bad torque converter
The torque converter is between the engine and transmission.The torque converter is between the engine and transmission.
You have to remove the transmission to replace the torque converter.You have to remove the transmission to replace the torque converter.
It is the part that the torque converter goes into in the transmission.It is the part that the torque converter goes into in the transmission.
The torque converter is located between the engine output shaft and the transmission. Have to drop transmission to remove.
i need to know what the torque specs are on the rocker arms for a 97 Chevy lumina, 3.1L v6
No , just the automatic transmission has a torque converter
That method results in a more accurate and even torque.
Torque for valve cover bolts is 7 to 10 ft. Lbs . Tighten the bolts in a criss-cross pattern .
The 4.3 liter Chevy Astro head gasket torque specification is 160 pounds. The head gasket bolts should be torqued in 40 pound intervals.
180 lb.feet of torque, for the 140 horsepower 3.1 litre v6
No, a manual transmission uses a clutch. Torque converters are used on automatic transmissions.
The torque converter solenoid is inside the transmission on the valve body.The torque converter solenoid is inside the transmission on the valve body.
The 1999 Pontiac cylinder head gasket bolt torque specification is 160 pounds. The intake manifold bolt torque specification is 90 pounds.
18 ft lbs
12 ft. lbs
The short bolt torque specs for the head gasket of a 2000 Pontiac Sunfire is 43 foot pounds. The torque specs for long bolts is 46 foot pounds.
I believe its in the transmission.you should be able to access it from the rear transmission cover.Its not easy to do ,the wheel has to be removed and trying to get the cover out is fun too.
I never went by any pattern and never torqued the bolts and never have had a leak on all the pans I have installed.
There is supposed to be a gap there to access the flex plate. More than likely the front seal on the transmission has gone bad or the torque converter has a leak in it.