There is no torque sequence just torque rocker arm studs to the proper torque
The rocker box bolt torque specifications, on your Harley-Davidson, is 15 pounds per square inch. The bolts should be torqued in five pound intervals.
The rocker box bolt torque specifications, on your Harley-Davidson, is 15 pounds per square inch. The bolts should be torqued in five pound intervals.
The 1984 258 cubic inch engine rocker arm bolt torque specification is 30 pounds. You should torque the rocker arm bolts in 15 pound intervals.
According to most Oldmobile torque specs, the correct torque for rocker arm bolts is 25 ft-lbs.
what is the engine torque spec for 1.6 opel monza
Boston 3.0 liter engine rocker arm bolt torque specification is 20 pounds. The rocker arm bolts should be torqued in 10 pound intervals.
NOTEStep 1: Tighten all bolts to 22 ft. lbs.Step 2: Tighten all bolts to 51 ft. lbs.Step 3: Loosen all bolts, in reverse torque sequence, by 180°Step 4: Loosen all bolts, in reverse torque sequence again by 180°Step 5: Tighten bolts #1 and #2, in the torque sequence, to25 ft. lbs.Step 6: Tighten bolts #3,4,5 and #6, in the torque sequence, 11 ft. lbs.Step 7: Tighten all bolts, in torque sequence, by 80-90°Step 8: Tighten all bolts, in torque sequence, again by 80-90°
The 2000 Chevy Impala 3.4 liter engine rocker arm bolt torque specification is 45 pounds. The rocker arm bolts should be torqued in 15 pound intervals.
The torque specs for a Cadillac depend on which engine it has. For most 425, 572, 368, and 500 engines, the torque for the head bolts is 115 ft. pounds. The torque for the cam bolts is 25 ft. pounds, and the torque for the valve covers is 10 ft. pounds.
No, head bolt torque is much higher than rocker arms.
Torque sequence------------ l 93157 l l 862410 l ------------ Step 1: torque in sequence to 44 Ft/LBS Step 2: in sequence completely loosen all bolts Step : retorque all bolts in sequence to 44 Ft/LBS Step 4: in sequence turn an additional 90 degrees Step 5: in sequence turn an additional 90 degrees Recheck final torque in sequence***CAUTION*** engine uses Torque To yield head bolts (TTY) that permanently stretch during the initial installation. New head bolts must be used when cylinder head is replaced or re-installed to obtain proper torque.
in sequence torque bolts to 20nm, then again in sequence turn a futher 120 degrees, and again in sequence 120 degrees.