Can i have the clutch pressure plate bolt torque setting not the FLYWHEEL BOLT
55 ft lbs then 120 degrees 55 ft lbs then 120 degrees
Torque specs pressure plate to fly wheel 60 series Detroit deisel
390 foot pounds
The oil pan bolt torque specifications, of a series 60 Detroit diesel engine, is 40 pounds. The bolts should be tighten by alternating end to end and side to side.
The amount of pressure you need to tighten nuts or bolts.
80Lbs for flywheel, 10 to 15lbs for pressure plate
35 ~ 46 Foot pounds of torque. Pressure plate bolts.
Yes, you have to torque everything on the drivetrain correctly. The manual calls for 15 ft-lb (dry and clean) on the pressure plate-to-flywheel bolts.
The torque setting for the pressure plate on the clutch for an s10 2.2 is 33 foot pounds. The torque for the 4.3 is 29 foot pounds.
72in-lbs
The crankshaft bolt torque specification is 240 pounds of pressure. The crankshaft bolts should be torqued in 60 pound intervals.
Pressure plate to flywheel bolts - 24 ft/lbs
pressure plate to flywheel bolts - 15 to 24
So that bolts are tight enough .but not overtight, and so many close bolts can all be the same pressure.