Torque the head bolt on a 1993 Toyoto 22RE three times at 58 foot pounds of torque. The 22RE head bolts are not torque-to-yield (stretch), and are re-usable. Torque is 55-63 foot pounds. Thoroughly clean the bolts on a wire wheel and inspect for pitting, especially in the threads and replace as necessary. It is also recommended to re-torque them after about 1,000 miles. ChaCha!
Torque as follows 53-63 ft/lbs. in 3 steps
The torque specs and pattern on the head bolts for a 1991 Toyota pickup with a 3.0 EFI is 50 foot pounds per bolt. The pattern is 4,5,6,3,7,2,8,1 with 1 being at the front of the engine.
The torque specs and pattern on the head bolts of a 1991 Toyota pickup with a 3.0 engine are 5, 4, 6, 3, 2, 7, 1, and 8. This sequence is started from the center of the head and requires 75 foot pounds of torque on each bolt.
Torque Value For 1987 R22, Per Haynes Manual - 58 ft lbs.
1991 toyota camry head bolts torque specs
58ft/lb
The torque specs for a Toyota Camry cylinder head is 60 pounds for the inside bolts and 50 pounds for the site bolts. The cylinder head bolts should be tight from and to end alternating.
waths the wey to torque the cylinder head
98 toyota tacoma head bolt specs
The torque specs for the cylinder head on a b2200 are 59-64 ft lbs (cold).
The 1995 Toyota Tacoma thermostat housing torque specification is 40 pounds. The amount of torque on the thermostat housing bolts is not that important. You basically do not want to break the thermostat housing bolts.
80Lbs for flywheel, 10 to 15lbs for pressure plate