to help it start running and idle
You can use a wire instead of the starter to test the tubes .. I did it, it works !
saanu ki pta
No it will not. If you need increase the supply voltage and remove the choke.
in 4 point starter we use a protactive rasistance to control the speed of motar in 3point starter speed is uncontolled
Ballast is purely a coil simply inductor that controls the current supplied to the tube. Of which there will be some loss and drop in power factor. Yet it is a good system which can handle the voltage fluctuations in the input. An electronic choke has 2 diode bridges and 2 major capacitors, by which the voltage and current supplied are controlled. The circuit operates in three stages. Voltage boosting is good and immediate, also eliminates starter. But this creates harmonics in the system which may disturb other systems if produced in large and it also cant handle the fluctuations.
You can use a wire instead of the starter to test the tubes .. I did it, it works !
It is the problem of Starter or Choke so you should check the starter and the choke. If they are damaged , you have to change these things.
Yes, but it is an automatic choke system called an auto by starter.
it will not glow
saanu ki pta
In a car it's the choke.
Put the choke in the full choke position. Hold the compression release in, twist the throttle fully open and kick the kick starter 8 times. move the choke to the half choke position and kick the kick starter 2 times with the throttle closed move the kick starter so that you are at the compression point at the bottom of the kick starter stroke and then use the compression release to move the kick starter just past the bottom (full compression) position kick the kick starter from the top all the way through the compression stroke. This will usually start the bike in 1 to 2 kicks, Note: using this method, you do not have to "stand" on the kick starter. If you have enough momentum from the top of the kick stroke, you will have a very easy time of it.
it have electronic inverter circuit
No it will not. If you need increase the supply voltage and remove the choke.
Yes
litteraly : your choke (device for helping petrol cars start)
COLD ENGINE STARTING OR STARTING AFTER REFUELING --Set unit on a flat surface. --Slowly press the primer bulb 6 times. --Move choke lever to FULL CHOKE position. --Squeeze the throttle trigger fully and hold through all remaining steps. --Pull starter rope handle sharply 6 times. --Move choke lever to HALF CHOKE position. --Pull starter rope handle no more than 6 pulls, until engine runs. --Allow engine to run 10 seconds, then move choke lever to OFF CHOKE position. RESTARTING A WARM ENGINE --Move choke lever to OFF CHOKE position. --Pull starter rope handle until engine runs. --If engine does not start in 5 pulls, follow instructions in STARTING A COLD ENGINE.