0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you use a torque wrench when the manual says to use a foot pound torque?
Use a torque wrench that is graduated in ft. lbs or do the math.
Can you use a torque wrench in both directions?
Yes, you can use a torque wrench in both directions.
How do you use torque in a sentence?
My car has lots of torque in first gear.
How do use torque in a sentence?
My car has lots of torque in first gear.
How do you measure torque for spark plug replacement?
You get the manual for the engine that you are replacing the plugs in then you use your torque wrench and tighten to the specified torque. If you have an aluminum head, be super careful and be sure to use the correct torque spec.
Do you need to use a torque wrench to loosen retractor seatbelt bolt on vw caravelle?
You don't use a torque wrench to loosen ANYTHING. -It is only for tightening nuts and bolts to the correct torque.
What does a mechanic use to tighten a car wheel?
A torque wrench, usually a power torque wrench
Where do you use torque while driving a car?
Torque is used when taking off or pulling a load. The more torque you have the faster the car will take off.
How do you torque a spark plug?
Use a torque wrench with the correct setting for your motor. See related link.
If you add an exton to your torque wrench does it change the torque?
as long as your extension is 90 degrees from the handle it will not affect your torque wrench. if you use a super long torque wrench you may lose a little torque in the extension it self but should not affect torque. an extension affecting the wrench in lenght like a crows foot will affect torque as long as your extension is 90 degrees from the handle it will not affect your torque wrench. if you use a super long torque wrench you may lose a little torque in the extension it self but should not affect torque. an extension affecting the wrench in lenght like a crows foot will affect torque
Can you use an automotive torque wrench for gun work?
No
How do you use an angular gauge on a torque wrench?
After torqueing I would use a regular ratchet with the angle gauge so you don't damage or through off the torque wrench calibration.
