Voltage regulation:(from point of view of electrical machines or generator):
It is the change in voltage in between the full loaded and no loaded condition.
When there are no loads connected the terminal voltage is equal to the generated voltage in the generator. But when load is connected the terminal voltage is found to be lass than the no loaded condition, due to armature resistance leakage reactance.This phenomena is expressed as, % reg=(Vnl-Vfl)/Vfl * 100%.Which is Voltage regulation.
************************************************************
An ideal voltage source has zero internal impedance. A practical one, even a good one, has internal impedance.
With no load on the source, the terminal voltage will have a given value.
Once a load current is drawn there will be a voltage drop across the source's internal impedance, and the terminal voltage will therefore drop. The higher the load current, the higher the voltage drop.
A regulator circuit, added after the source, can counter the effect of the source's impedance and maintain an output voltage which is more constant than the source itself can achieve.
yes.. voltage regulation can be negative
Regulation =(Obtained voltage per phase - rated voltage per phase)/rated voltage per phase *100
'Zero voltage regulation' indicates that there is no difference between its 'no-load voltage' and its 'full-load voltage' -this is only the case for an 'ideal' transformer.
People have used a ballast for current regulation and you can use a breakdown diode for voltage regulation.
raised voltage output
yes.. voltage regulation can be negative
Percent Regulation is the regulation expressed as a percentage is a figure of merit used to specify the performance of a voltage regulator.
The change in output voltage from no load to full load defines the voltage regulation of that transformer.
A transformer will operate with a voltage regulation of zero when it is not supplying a load.
A transformer will operate with a voltage regulation of zero when it is not supplying a load.
Regulation =(Obtained voltage per phase - rated voltage per phase)/rated voltage per phase *100
'Zero voltage regulation' indicates that there is no difference between its 'no-load voltage' and its 'full-load voltage' -this is only the case for an 'ideal' transformer.
Line regulation is a measure of the ability of the power supply to maintain its output voltage given changes in the input line voltage. Line regulation is expressed as percent of change in the output voltage relative to the change in the input line voltage.
To regulate the voltage
People have used a ballast for current regulation and you can use a breakdown diode for voltage regulation.
raised voltage output
change in voltage from no load to full load