Most likely, your steering lock has engaged. You simply need to turn the steering wheel in either direction while you turn the key and it will start right up.
turn signal located on VT commodore
why wont the wip ers on a vr Holden commodore turn off, its in the off position,but they keep going ,the only way you can turn them off is turn the car off ,when you start the car they come on. you switch them off with the little hand piece on the right of the steering colume and they just keep going.
It is located under the steering cloumn
hi, open the plastic door under the steering column there should be a diagram inside the door to guide you. There are 4 relays above the fuse panel A,B,C,D the flasher is D.
The VT Commodore might turn over a few times and then start if there are teeth missing on the flywheel. The starter wires might also be shorting out or loose.
Its likely it could be your crank angle sensor. take it to the mechanic and get it scanned. the problem should show up
Depending on the type of service light, the Holden Cruze offers and easy way to reset the light. Turn the ignition to on, but do not start the car. Depress the accelerator three times within five seconds, and then turn the ignition off.
Does it turn over? yes Does it have spark? yes Does it have fuel?yes
Sounds like you need a new starter!
Does it turn over? Does it have spark? Does it have fuel?
It isprobably not getting fuel or not getting spark.
Could this be a fuel filter or fuel pump problm?