Auto Parts and Repairs
Headlights Tail and Brake Lights
Ford Ranger XLT
Turn Signals and Hazard Lights

What is wrong if you have no turn signals or brake lights on a 1988 Montero everything else works?

323334

Top Answer
User Avatar
Wiki User
2004-10-25 16:22:16
2004-10-25 16:22:16

check fuses then check all the bulbs, then check the turn signal switch the brake lights work through it

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

my daughters 1991 miusbishi montero has no break lights , turn signals or hasard lights . All tail lights and front markers are working. All fuses are cking good and all bulbs are good..Is my blinker switch bad ? capri

User Avatar

Break lights come on when you step on the break, they do not come on when the head lights are turned on.

User Avatar

Brake lights and turn signals are on a separate circuit from the tail lights. Tail lights are on the same circuit with the dashboard lights. If the dashboard lights aren't working either, check the fuse. If they ARE working, check the headlight switch.

User Avatar

It is not necessarily the fuse. It could be the switch on the brake that is not closing the circuit.

User Avatar

i have tail lights but do not have brake lights nor do i have turn signals. i have replaced brake switch and all bulbs

User Avatar

im not familair with that make of vehicle but. the brake lights anf the signals are supposed to be separte. they both plug into a harness near the back of the vehicle. if your brake lights are working with your signals, you might have something crossed. take it to an expert you trusst and let them check it out.

User Avatar

The brake lights in your 1983 Nissan pickup truck are controlled by the brake light relay switch. When the brake light relay switch malfunctions the brake lights will stop working.

User Avatar

If the vehicle is equipped with a trailer light plug, the wires for the brake lights and the turn signals have been connected together, which is common, as many trailers do not have separate lights for brakes and turn signals.

User Avatar

if the tail lights work but not brake lights then its most likely just a blown fuse or it could be the switch at the top of your brake pedal arm.

User Avatar

replace brake light switch on brake pedal

User Avatar

If all the fuses are good, then most likely the brake light switch right on the brake pedal inside the car. Check that.

User Avatar

You have a short, you also may have to check your bulbs i found on one of my blinkers the bulb was faulty, i replaced it and everything was all fine again.

User Avatar

I am having the same trouble. My brake lights work with the light switch for nighttime driving, but only far right brake light works when i pres brake pedal. Reverse lights dont work at all. Turn signals and hazard light work.

User Avatar

Turn signals use a relay or 'flasher' which is usually located on or near the column under the dash. Brake lights get their power thru the brake light switch on or near your brake pedal under the dash; check it with a 12v circuit tester.

User Avatar

if its not registered for the street and has no lights, signals, brake lights then yes it is.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.