Fuel Filters
Fuel Pumps
Nissan Altima

What is wrong when a 1995 Nissan Altima GXE is not getting fuel to the engine?

678

Top Answer
User Avatar
Wiki User
Answered
2006-03-27 01:02:55
2006-03-27 01:02:55

fuel pump, wiring, relay, clogged filter,kinked fuel line.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


something wrong on the engine get it chek for any codes

There is something wrong. Go to auto zone and have the codes read for free.

if your take it to a autozone tell them you have a check engine light and they will tell you whats wrong if anything and reset it take it to autozone and tell them your check engine light is on and they should reset it

Read the owners manual and u can't go wrong..

When i accelerate it goes slow i think my timing was set wrong a couple of times not just once

It sounds like a spark problem. Check if there is spark. Suspect the coil. Then inspect the fuel system, may not be getting fuel. Check fuel pump.

it's broke. if you car is not going into gear then it could be the trasnmision

The 93 - 97 firing order is 1-3-2-4. this is wrong for a 96 altima with dc it is 1234 on engine and the cap is numbered thank u a**hole for giving a wrong answer 93 97 yeah right made me look like an a** got it fixed now!!!!!!! bi**h it is 1342

If your wipers keep blowing the fuses on your 1998 Nissan Altima, it could be a short or the wrong fuse being used. You may have a short in the wiring or the wiper switch, a bad ground wire, or loose wiring.

Have you checked the fluid level? Have you changed the filter and fluid as normal maintenance?

Sea Foam has several products for different purposes. Perhaps you used the wrong stuff.

The AT check signal light means that there is something is wrong with the transmission. A slipping transmission can be the cause of this.

it can be if you keep driving your car like that. could end up buying a new engine.. it could be a crack cylinder FIX ASAP!!

Need to know year and engine size, as there are many different ones, the almera uses both long and short reach plugs, so getting the wrong ones (long reach in a short reach engine) can be a disaster.

there several modules, what am sure of is the "service engine" : if you are %100 sure that there are nothing wrong in your car the you can go for reset procedure by disconnecting the + connector (hot) of the battery under the hood & keep it disconnected for around 30 minutes. reconnect & the light should be gone.

If oil inside your spark plug how do u clean it out n what wrong with the car

The Villager is NOT an interference engine. This is straight from a guy who was engineering liaison between Ford and Nissan on this project. The catalogs that say it is are WRONG.

The Villager is NOT an interference engine. This is straight from a guy who was engineering liaison between Ford and Nissan on this project. The catalogs that say it is are WRONG.

dont do it yourself!! take it in i know its going to cost atleast 80$ but its better someone that knows what to do, than having to think oh what did i do wrong?

Here's some pics of my 2003 Altima Crankshaft Sensor. Often mistaken by the Camshaft Sensor because both are identical sensors. They are each located in different locations. I've seen diagrams with the WRONG labeling. Again, this is so confusing for even a mechanic to understand because both sensors carry the same part number which is rare. http://x.nissanhelp.com/forums/members/digitaldxing-albums-2003-Nissan-altima-crankshaft-position-sensor-picture331-2003-Nissan-altima-crankshaft-position-sensor.HTML Here's the answer for everyone that has a 2003 Nissan altima 3.5 liter the vq35de engine not the qseries. In the vq35de, the crank position sensor is not located in the back. Iv looked all over for its location and took hours to get no where. It is simply located right below the air intake, on the right front side of the oil pan, located below starter. Here is the diagram.. http://www.justanswer.com/Nissan/3anvu-crankshaft-position-sensor-2003-altima-vq35-au.HTML so don't go to dealer have have them charge you 200 bucks to install it,even after they told you your car isn't on the recall list. It takes 3 mins to replace old one with new.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.