answersLogoWhite

0


Best Answer

The VSS (vehicle speed sensor) may be At Fault.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is wrong when the speedometer and rpm gauge stops working and the trans slips?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What if your speedometer stops working?

You get it fixed at agarage


When the thermostat gauge stops working is it just the gauge or the thermostat?

most likely the gauge


What do you do when the speedometer stops working in a 1990 subaru legacy?

Guess! And follow ppl.


Where is the fuse for gas gauge on Chevy Malibu?

If the gas gauge stops working is there a fuse for it?


What does it mean when your mph stops working?

If the speedometer and odometer both quit I would blame the speed sensor. If only the speedometer quit I would blame the instrument cluster.


How do i fix my speedometer when it stops working for my 1997 Mitsubishi colt?

this question should be listed under automobiles repair


Why does speedometer needle jump around then stops working on a 1998 Buick Regal GS Supercharged?

Sounds like a bad cable


How much does it cost to repair the speedometer when it stops working on a Dodge Ram 1500 Sport Quad Cab 1998?

$1500-$2000 to suck it


What is wrong with your car the speedometer works when im driving on the highway than when Im in smaller traffic it stops working?

The speed sensor is bad.


Why did speedometer stop working and traction disable light come on?

When the speedometer stops working and the ABS or traction disabled light comes on in a vehicle it indicates that the vehicle's ABS system is faulty. This could be indicative of a faulty wheel sensor or the ABS tracking system itself.


Why does the Fuel gauge stops working and truck sp spudders 97 Chevy pickup?

Because it's stuffed


Do i need to replace a fuse when the speedometer stops working on a 1988 grand marquis?

There is a small plastic gear in the gauge cluster that is prone to failure. Buy a set (2 parts, 1 each) here and replace it. This requires removing some trim but is a reasonable ~3 hour project for most DIY people. I'm assuming you have an analog gauge. Good luck.