• Chrysler Town and Country
  • Ford Explorer XLT
  • Grand Am SE

What is wrong with 95 Chrysler town and Country 3.8 when you put the van in gear and it dies?

User Avatar

Wiki User

βˆ™ 2006-08-21 20:27:08

Best Answer

Your idle speed might be too low, clogged air filter, timing could be drastically off, or it could be electrical. Good luck

User Avatar

Wiki User

βˆ™ 2006-08-21 20:27:08
This answer is:
User Avatar

Your Answer


Related Questions

What is wrong with 1996 Chrysler town and country 3.8 when you put the van in gear and it dies?

This may sound strange but it works. Bang on the dash two or three times. i no I no........until the van stays running. Try it.

A 1984 Honda Accord runs fine until put in gear then engines dies not sure what is wrong?

If the 1984 Honda Accord engine dies when put in gear then it could be due to some faulty wiring.

Why wont your Chrysler town and country downshift back into first gear?

The transmission computer defaults to second gear when it detects a malfunction and sets a code.

Where is the planetary gears in a Chrysler Town and Country van?

It's the main drive gear mechanisms in the transmission.

What could be wrong if a 1990 F150 pickup dies when it is put into gear?

Torque convertor could be defective siezed up.

Motorcycle jumps and dies when put in gear even with the clutch pulled in what could be wrong?

Your clutch needs adjusted or replaced.

Could you tell me what is wrong when i put my Kubota lawn mower in gear and it dies?

Seat switch; it does not know the seat is occupied.

What type of gear oil for a AWD 2001 Chrysler Town and Country rear differential?

80W90 SAE MOPAR 4874468

What would be wrong with your transmission if it locks into second gear on a Chrysler Concorde?

That happens when the computer detects a problem.. You need to have the computer checked for trouble codes.

What gear is the best to drive a 2002 Chrysler town and country minivan in town?

Put it in OD and let the auto trans do its thing.

What does p0731 mean on a Chrysler 300?

Incorrect gear ratio in first gear.Incorrect gear ratio in first gear.

Why won't 91 Chrysler imperial shift out of low gear?

It is most likely stuck in second gear which is the "Limp" mode on the trans. There is something wrong with the trans and it should be taken to a good trans shop to be scanned for problems.

Why does my 2006 Chrysler Town and Country make a clicking noise when braking?

If your talking about when your in park that click is releasing the transmission so you can shift into gear

What is the diagnostic code P0731 for a 1998 Chrysler Concorde?

Gear ratio error in first gear.

What is wrong when a 1999 gsxr dies when you put it in gear?

the sensor for your side stand may not be working so it thinks the stand is down and cuts out as a safety feature.

What could cause a 2002 Chrysler town and country van not to shift out of low gear?

When the trans computer detects a malfunction it sets a trouble code and defaults to 2nd gear. You need to have it checked for codes to know what to diagnose.

If a car won't move when it is in gear what is wrong?

the gear you have it in might be neutral.

What might cause a 1996 Chrysler Town and Country to not shift out of second gear?

More then likely, one of the electronic solenoids in the control pack on the front of the transmission case.

How much gear lube to refill Chrysler 8.25?

About 5 pints

What would cause the transmission to be stuck in second gear in a 1994 Chrysler Town and Country?

The transmission computer defaults to second gear when it detects a malfunction and sets a code. You need to have the system checked with a scan tool to know possible causes.

How do you get a 2005 Chrysler out of park?

If it is like most Chrysler Autos, you need to put your foot on the brake pedal before shifting into gear.

Does a 1986 Chrysler Lebaron have rack and pinion or a steering gear?

It has a rack and pinion.

What cracks gear box of Chrysler grand voyager?

An internal failure of the differential.

Is there a timing chain or a timing gear in a Chrysler 1996 Town and country with a 3.8 liter motor When is it supposed to be replaced?

There is both a timing chain which connects to a timing gear (cam and crank shafts) Not as regularly scheduled maintenance item - replace only when needed

Will a 3.3 liter v6 Plymouth grand voyager transmission mount up to a Chrysler town and country 3.8 liter v6?

Yes it will but the gear ratio will be a slight bit different.