I would have to say that something is wrong with your throttle position sensor, throttle relay, or your throttle is dirty and sticking. I would check the sensors and the relay with a volt meter first. You can take off the air intake hose and see if your throttle is dirty. If it is just get some carb cleaner and spray in it. That should take care of the problem.
CORRECTION: YOU HAVE A STICKY THROTTLE CABLE. GO TO A MOTORCYCLE DEALER PARTS DEPARTMENT AND ASK TO PURCHASE A CABLE LIBRICATION TOOL.
OPEN THE HOOD, ON THE FLOORBOARD INSIDE THE CAR, PLACE LOTS OF NEWSPAPERSAROUND THE THROTTLE PEDAL (ITS GONNA GET MESSY), LOCATE THE THROTTLE CABLE (TOP CENTER OF MOTOR OFF TO THE PASSENGER SIDE UNDER A 5X5 IN BLACK PLASTIC COVER) AND CLAMP THE NEWLY PURCHASED TOOL, AND WHILE YOU ARE ARMED WITH WD40 OR LIQUID WRENCH (EITHER IS GOOD AND MUST HAVE A PLASTIC STRAW WITH IT, PLUG THE STRAW INTO THE HOLE ON THE NEW TOOL AND SPRAY FOR 2 MINUTES...
NO MORE STICKY CABLE, FLOOR AT WILL....
It is worth a nickel
The fuel pump is located in the fuel tank.
How to change the alternator in a 1989 Honda accord lx
A repair manual for that vehicle would have that info.
That card is worth 25 cents in MINT condition, with no flaws.
Sure, turn it sideways and push it in the back hatch
Autozone.com has vehicle repair guides. You should check it out and know what size your engine is.
The transfer case will not bolt to a 2wd transmission.
It is the tiny valve that lets air in to your tire but not out (unless you push it in with a nail or similar "pointy" thing)
First check the fluids. Then if that isn't the issue, check the thermostat. I ran my car hot, and fixed it yesterday.
where is the cranking senor on a1989 ford gt escort
drain coolant then remove thermostat housing remove thermostat replace with new one spring to block
Something can be taxing the work of the alternator, or the alternator can be weak and needs replaced.
It will bolt right in but, the "Y" pipe on the exhaust system from the 305 will not fit on to the 350.
1 Liter = 61.023744 cu. in.; 4.3 Liters = 262.40209 cu in.
The inertia switch is located on the driver's side of the firewall to the left of the brake pedal or behine the right kick panel.
Yes, I do, but in order for you to obtain one you will need to go to an auto parts store. Haynes makes a manual specific to your car.
what do all the dash board warning lights mean on a1989 mercedes benz
vacuum leaks, stuck or leaky egr valve, leaking intake, bad valves, ect
It looks like a1989 dodge dynasty! Go to your browser search, and type in pictures of 1989 Dodge dynasty and you will see what a 1989 Dodge dynasty looks like.
maybe low on fluid? or maybe bad thermostat? or maybe bad water pump?