Some cars have a safety feature that won't allow you to drive them if the brake pads are severly worn. Remove each tire and check pads. Replace if bad. You may need to reset ABS if the light does not go off. Some cars will reset after removing - battery cable for 20 min. Chris
The abs light stays on when the computer has detected a malfunction and set a trouble code.
check the water level... if that's good try a new thermostat...
You may need to change the indicator bulb, that's what was wrong with mine.
Because your foot is on the gas and something is wrong with your engine.
The security wire is either disconnected or shorting.
Lexington and Concord is located in Massachusetts. Check google for more information. This answer may be wrong.
That's the computer's way of telling you that something is wrong and it wants you to read the diagnostic code.
you may have a circuit or you can check your doors for any malfunctions
The main problem might just be you mate.
New Alternator BUT Warning Light Still Stays OnMaybe there was nothing wrong with the alternator you replaced, and the problem is somewhere else in the charging system!Although possible, it is highly unlikely that a new alternator would be defective.
Bad tire Bad CV joint Bad Tie rod end
You are leaking (internally or external) the coolant. With out knowing the code that has set, it is impossible to say the cause of the light.
=I don't know about the brake lights. I know that most cars, when you turn it off and get out, the head lights and main backlights stays on for a while but then goes off. The brake lights? Maybe it's the way that car is or something is wrong with the brake or you have it on wrong.=
Cold air from the defrost indicates that the air doors are in the wrong position. The doors are vacuum controlled in most vehicles. check the vacuum system for a leak.
fix the problem and the light goes off its sensors or cat converter but if it runs good don't worry drive it there is nothing really wrong with it light just stays on
you have a brake problem and need to have it repaired before you can reset the light sensor you have a brake problem and need to have it repaired before you can reset the light sensor
The only way you can know what's wrong for certain is to connect a code scanner.
This may sound strange but it works. Bang on the dash two or three times. i no I no........until the van stays running. Try it.
There are dozens of things that turn the light on. TAke it to auto zone and have the codes read.
You need to find out why the light is on before trying to reset it. Have your local auto parts store read the code(s) and determine what is wrong. They will do this at no charge to you.
If the ABS (antilock brake system) light stays on, there is a problem with the system and it will not function should you need it in a panic situation. Have a mechanic repair it soon for your safety.
go to an auto parts store most will put on computer for you for free
There are pages and pages and items that can cause a check engine light. You need to have it checked for codes with a scan tool. After repair light can be shut off with scan tool.
they concord because the Spaniards were getting alot of islands for themselves which means they are getting all the money and the british wanted to prove them wrong
Check engine light could be anything. usually related to emissions system failure of some kind. lots of auto stores will let you use there tool that will plug into your cars diagnostics and will give a code for what is wrong